Storage - AR Blue Clean AR 383 Manuel Du Propriétaire

Fig. 22
Fig. 23
four power washer detergents. They are Auto, Motorcycle,
Boat and Universal. These can be purchased online at
our website www.arblueclean.com. Hardware stores
or home centers also have power washer detergents for
GHA
different cleaning projects. The cleaning solution should be
the consistency of water in order to prevent clogging your
detergent bottle and nozzle.
• When using the detergent bottle, our power washer's
application ratio of water to detergent is 10:1 or 10 parts
water to 1 part detergent. You will need to adjust the
concentration ratio of the detergent, according to the
manufacturer's instructions.
• This system applies detergent under low pressure. The
cleaning power of the detergents is enhanced when applied
with low pressure; and time is allowed to break down the dirt
and grime. The combination of low pressure and chemical
action is very effective and can be better than scrubbing if
applied properly. Always spray detergent on a dry surface,
do not pre-soak area. Wetting the surface first dilutes the
detergent and reduces its cleaning ability. Do not allow
detergent to dry on surface. On vertical surfaces being
cleaned, apply detergent to lower surfaces and work your
way up to prevent detergent from causing streaks in the
dirt and grime. Rinse detergent by pressure washing from
bottom up for same reason.
Pump
• If a stain is particularly tough, it may be necessary to reapply
the detergent and use a stiff bristled brush to scrub the
stain. Subsequent power washing after brushing should
High Pressure Hose
Fig. 24
successfully complete your cleaning job.
s
torage
• When your pressure washing session has been completed,
turn off the power switch located on the back of the power
washer. Unplug the power cord from the outlet. Turn off the
water supply. Pull the trigger on the spray gun 2-3 times
to drain out the excess water and to release any remaining
water pressure. Disconnect the garden hose adapter from
the water inlet. Do not allow the power washer to run with no
water flowing through it.
• The GHA should be stored in the accessory holder when your
unit is not in use to prevent loss or damage (Fig. 22).
• Remove high pressure hose from spray gun (Fig. 23) and
unscrew the other end of the high pressure hose from the
power washer (Fig. 24).
• Remove lance or detergent bottle from the gun and place in
the accessory holder. Place the gun in the accessory holder
in one of the slots. Lances are pressed into and stored in
the half circle notches (Fig. 22). Make sure to discard any
remaining detergent from the bottle. Flush the bottle and
En - 11