29. Never use a water supply to your power washer that exceeds 150 psi
maximum.
30. Never disconnect the high pressure hose from the power washer while the
system is pressurized.
31. Never permanently engage the trigger mechanisms on the spray gun.
32. Never operate the power washer unless all components are properly and
securely connected.
33. Never allow the power washer pump to run for more than one minute, after
you have turned off the water supply. This can cause the motor and pump to
overheat and fail.
34. Never use lances or other parts that have not been supplied with your power
washer.
35. Never use an extension power cord since it defeats the effectiveness of the
GFCI and increases the chance of electrocuting the operator.
36. Never spray any electrical outlet with your power washer.
37. Inspect the power cord before using. Do not use it if it is damaged.
Servicing of a Double-Insulated Appliance
GROUND FAULT CIRCUIT INTERRUPTER PROTECTION
This pressure washer is provided with a ground-fault circuit-interrupter (GFCI)
built into the plugs of the power-supply cord. This device provides additional
protection from the risk of electric shock. Should replacement of the plug or
cord become necessary, use only identical replacement parts that include GFCI
protection.
In a double-insulated product, two systems of insulation are provided instead of
grounding. Grounding means are not provided for a double-insulated product, nor
should grounding means be added to the product.
Servicing a double-insulated product requires extreme care and knowledge of
the system, and should only be done by quailed service personnel.
Replacement parts for a double-insulated product must be identical to the origi-
nal parts. A double-insulated product is marked with the words "Double Insula-
tion" or "Double Insulated". Product may also be marked with symbol shown
here.
En - 5