Description Of Components - Silverline AH18NCPR Mode D'emploi

EN

Description of components

Main power switch
Control panel
M6x16 (x2)
Screw
Installation
Drill 2 holes in the wall or ceiling as shown
in fig A. Fit the expansion bolts in the holes,
and tighten them with a spanner until they are
firmly fixed in place. Remove the nuts, spring
washers and washers for later use. NB! If a
different mounting than the expansion
bolts supplied is to be used, check that
the heater's weight can be borne by the
surface and by the mounting components.
Mount the two L-brackets on the expansion
bolts and replace the spring washer, washer
and nut, and screw the brackets firmly in place.
Screw the other brackets to the rear of the
heater using 2 M6 x 8 screws on each side.
Mount the heater on the brackets on the wall/
ceiling. Use one M6 x 16 per side and tighten
using the Allen key supplied. For wall mounting,
make sure you mount the heater so that the
control box is on the left side.
By loosening the screws that hold the brackets
together, you can adjust the angle of the heater
as shown in fig B. Always ensure that you
tighten the screws properly after adjusting the
angle of the heater.
26109 Wall IP65_Manual.indd 13
Allen key Expansion bolt M6*70
858 mm
(x1)
(x2)
M6x8 (x4)
Fig A.
Fig B.
Comfort Heating system
L-bracket
Washer
Spring washer
Nut
858 mm
718 mm
®
Wall (x2)
Heater (x2)
718 mm
2017-12-18 11:21