Fitting And Adjusting The Carrying System; Adjusting The Loop Handle; Inserting And Removing Connecting Cable Plug; Inserting The Connecting Cable Plug - Stihl KMA 130 R Mode D'emploi

English
► Push battery (4) as far as it will go into the belt
bag (5).
A short beep will sound.
► Secure battery (4) with the Velcro® fasten‐
ing (6).
7.3.2 Adjusting the Connecting Cable
The connecting cable can be fitted and adjusted
to suit the user's size and the application.
3
The length of the connecting cable can be adjus‐
ted by making a loop (1) and securing it to the
belt bag (3) with the fastener (2).
► Arrange the connecting cable so that it is as
short as possible without hindering your work.
7.3.3 Fitting and Adjusting the Carrying Sys‐
tem
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the cara‐
biner (2) is about a hand's width below your
right hip.
7.4

Adjusting the Loop Handle

The loop handle can be set to different positions
to suit the height and reach of the user.
► Switch off the KombiMotor and pull the con‐
necting cable plug out of the socket.
26
2
1
1
2

8 Inserting and Removing Connecting Cable Plug

► Loosen the screws (2).
► Move the loop handle (1) to the required posi‐
tion and make sure that:
– The spacer sleeve (3) fits between the loop
handle (1) and carrying ring.
– 'a' = no more than 25 cm.
► Tighten down the screws (2) so that the loop
handle cannot be rotated on the drive tube.
8 Inserting and Removing
Connecting Cable Plug
8.1 Inserting the Connecting Cable
Plug
► Hold connecting cable plug (2) so that the
arrow on its side lines up with the arrow on the
socket (1).
► Insert the connecting cable plug (2) in the
socket (1).
The plug (2) engages in position.
8.2 Removing the Connecting
Cable Plug
► Grip the connecting cable plug (2) with your
hand.
► Pull the plug (2) out of the socket (1).
a
1
2
3
1
2
1
2
0458-805-9621-B