VONROC TM503 Série Mode D'emploi page 7

2. Mark a minimum of three mounting holes using
the wall mount (1) as a guide. Use the provided
spirit level (6) to ensure the wall mount (1) is level.
3. Pre-drill the holes to a minimum depth of 55mm
using a 4.5mm drill bit. If installing in hard-
wood, a slightly larger diameter and deeper
hole may be required.
4. Place the washers (W-C) onto the lag bolts (W-
A). Attach the wall mount (1) to the wall using
the lag bolts (W-A).
5. To install the wall plate cover pieces (4/5), first
slide the top and bottom pieces (4) into place
(see figure F), then attach the center piece (5).
Option B: Installing in masonry (Figure E, F)
Ensure there is a minimum of 35mm of
actual concrete/brick thickness in the
location of each hole.
Drill into solid concrete/bricks only. Do not
drill into mortar joints.
1. Mark a minimum of three mounting holes using
the wall mount (1) as a guide. Use the provided
spirit level (6) to ensure the wall mount (1) is
level.
2. Drill the holes to a minimum depth of 60mm
using a 10mm masonry drill bit. Clean out the
holes after drilling.
3. Fully insert a concrete anchor (W-B) into each
hole. Tap the anchor in using a hammer if requi-
red.
4. Place the washers (W-C) onto the lag bolts (W-
A). Attach the wall plate (1) to the wall using the
lag bolts (W-A).
5. To install the wall plate cover pieces (4/5), first
slide the top and bottom pieces (4) into place
(see figure F), then attach the center piece (5).
Attach Mounting Arms to TV (Figure G)
1. Using a second person for assistance, lay your
TV face down on something soft so as not to
scratch the TV screen. Check the back of your
TV to find the appropriate mounting pattern.
WWW.VONROC.COM
Do not place the TV face down onto a table
smaller than the TV itself, as doing so may
crack or damage the TV screen.
2. Sort through the provided bolts (M-A through
M-E) until you find the correct size that fits
into the mounting holes on the back of your TV.
Test if the bolts can be tightened by hand for at
least three full turns. Do not yet fully tighten the
bolts.
If you feel resistance while turning the bolt
you must stop immediately and select a
shorter bolt. Forcing in an oversized bolt
may cause damage to your TV (see figure H)
3. Remove the bolts from the TV once you have
selected the correct bolt size.
Refer to your local hardware supplier for the
correct bolts and washers if none of the
supplied bolts will fit your TV.
4. Gently place the mounting arms (2) on the back
of the TV. If the back of your TV is curved or re-
cessed you may also need to use one or more of
the supplied spacers (M-G or M-H). When using
a spacer you may also need to use a longer
bolt. Keep in mind that the bolt must always be
able to turn at least three full turns (see figure
H).
5. Place the multi-washers (M-F) onto the previ-
ously selected bolts. Attach the mounting arms
(2) to the TV using the bolts. Do not over tighten
the bolts, as doing so may cause damage to
your TV.
Attach TV to wall (Figure I)
1. Using a second person for assistance, carefully
lift the TV and hook the arms (2) over the top of
the wall mount (1).
2. Slowly lower the bottom of the TV until the
bottom of the mounting arm (2) locks into the
bottom of the wall plate (1).
3. Once the TV is in place, secure it by tightening
the bolts (8) at the bottom of the mounting
arms (2)
EN
7