FAAC TM2 PPR Mode D'emploi page 25

TOTAL DELETION OF REMOTE CONTROLS FROM
MEMORY
The memory can be completely erased in two ways:
1) USING THE REMOTE CONTROL
Tn: Memorised remote control
+
A B
Tn
2) USING THE AUXILIARY WIRE (WHITE OR BLACK)
Use this option in an emergency or if a working remote control is not available. The
white or black wire of the motor has to be accessed in order to delete the memory.
The sequence of operations is as follows:
1) Turn off the power to the motor, for example by using the main switch.
2) Connect the white or black wire of the motor to the brown wire (phase) or to
the blue wire (neutral).
3) Turn on the power to the motor, which will carry out a short rotation in one
direction.
4) Turn off the power to the motor for at least 4 seconds.
5)Turn on the power to the motor, which approximately 2 seconds before and 6
seconds after, will carry out a short rotation in one direction and a longer rotation
in the other direction.
6) Turn off the power to the motor.
7) Separate the white or black wire from the brown or blue wire. Insulate the white
or black wire before turning the power on.
It is now possible to start to memorise the first remote control.
2 sec.
TM2 PPR
B
Tn
6 sec.
25
+
A B
Tn (4 sec)
A4518_6G85_Rev.B