Operating Mode - FAAC TM2 PPR Mode D'emploi

OPERATING MODE

The motor is simple to install and easy to use, it does not need to be adjusted as
it automatically recognises the limit stops.
The roller shutter must be fitted with:
A - Rigid straps or anti-burglary springs
B - Fixed or removable safety plugs in the guides
It is recommended that you always check the strength of the shutter.
A
MEMORISING THE FIRST REMOTE CONTROL
This can only be carried out when the motor is new, or after the memory has been
completely erased.
Only switch power on to one motor at a time when doing this.
T1: First remote control to be memorised
+
A B
T1
Each time the motor is switched on, you have up to 3 hours in which to memorise
the first remote control. Once this time has elapsed, it is no longer possible to
memorise the remote control. To reset the timer of the function, simply switch
the motor off and on again.
TM2 PPR
B
B
AUTOMATIC DISABLE FUNCTION
FIRST REMOTE CONTROL MEMORISATION
N.B. until the remote control has been
memorised, the wired control of the
motor will operate in "dead-man" mode.
T1
22
B
T1 (2 sec)
A4518_6G85_Rev.B