EIBENSTOCK EHR 750 B Notice Originale page 22

Defect
Engine does not
start or starts,
but does not run
further.
Engine starts,
but does not run
at full power.
Engine splutters
The motor does
not develop
maximum
power
Engine does not
run smoothly.
Excessive
exhaust gases
(smoke).
When transporting the tool by car, it must be positioned so that it poses no
danger, and secured. Make sure that no petrol escapes during transport.
Avoid damage and injuries.
Lock the device in a proper place to protect it from unauthorised use.
After every work stint, clean the machine thoroughly to remove all dust and
debris, and repair or replace any faulty parts. The appliance must be stored
in a dry place and protected from frost.
FAILURE REMOVAL
Cause
Wrong starting process.
Empty fuel tank/Lack of fuel
Wrong fuel, storing
petrol tank being drained
Wrong setting of the carburettor.
Sooted spark plug
residues on
electrodes distance too big.
The spark plug is wet from
petrol.
Dirty air filter
Dirty air filter
Wrong setting of the carburettor.
Dirty air filter
Wrong setting of the carburettor.
Transport
Storage
Removal
Refer to the instructions in
these operating instructions.
Add some fuel
without Drain
carburettor. Add fresh petrol.
Have the carburettor settings
adjusted
customer service organisation.
(carbon Clean the spark plug, check
electrodes), the
possibly change the plug.
Dry the spark plug out and re t
it.
Clean or replace the air filter
Clean or replace the air filter
Have the carburettor settings
adjusted
customer service organisation.
Clean or replace the air filter
Have the carburettor settings
adjusted
customer service organisation.
22
the fuel tank
by an authorised
plug thermal
by an authorised
by an authorised
and
value,