14 electrolux
2. Turn counter-clockwise the spacers through
45° until they lock into place.
Levelling
When placing the appliance ensure that it stands
level. This can be achieved by two adjustable feet
at the bottom in front.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by
one or more adjustable feet at the base of the cab-
inet.
If the cabinet is placed in a corner and the side with
the hinges facing the wall, the distance between
the wall and the cabinet must be at least 10 mm
to allow the door to open enough so that the
shelves can be removed.
Warning! It must be possible to disconnect
the appliance from the mains power supply;
the plug must therefore be easily accessible after
installation.
Door reversibility
Important! To carry out the following operations,
we suggest that this be made with another person
that will keep a firm hold on the doors of the
appliance during the operations.
To change the opening direction of the door, do
these steps:
1. Remove the plug from the power socket.
2. Open the door of the freezer. Loosen the
hinge.