Thule RodVault ST Instructions D'utilisation page 4

Thule RodVault ST
870011
NOSE CONE SECTION/REEL HOUSING SECTION MOUNT
1. Using the Small Tube Clamp, place the top (the side
with the DO Logo) underneath the tubes of the Nose
Cone Section.
2. Place the Bottom Tube Clamp on top of the tubes
and secure with Mounting Clamp Assembly and 3.5"
King Bolt as shown in Figure 3
3. Leave the Small Tube Clamp loose so it can slide up
and down the Nose Cone Section for placement on
crossbars.
Using the Large Tube Clamp, place the top (the side
4.
with the DO Logo) underneath the tubes of the Reel
Housing Section.
5. Place the Bottom Tube Clamp on top of the tubes
and secure with Mounting Clamp Assembly and 3.5"
King Bolt as shown in Figure 6
T-SLOT/REEL HOUSING SECTION MOUNT
1. Slide the 2 T-slot Bolts into the T-slot (for Thule
Xsporter use longer 2.75" T-slot bolts)
2. Using the Large Tube Clamp, place the top (the side
with the DO Logo) underneath the tubes of the Reel
Housing Section.
3. Place the Bottom Tube Clamp on top of the tubes
and using ¼ inch Hex Wrench secure Mounting Clamp
Assembly with 3.5" King Bolt as shown in Figure 6
Leave the Large Tube Clamp loose so it can slide up
4.
and down the Reel Housing Section for placement on
crossbars.
5. Place the unit on top of your vehicle
6. For the Reel Housing Section mount, position the
mounting assembly over the front crossbar making
4
Leave the Large Tube Clamp loose so it can slide up
6.
and down Reel Housing Section for placement on
crossbars.
7. Place the unit on top of your vehicle
8. For the Nose Cone Section mount, position the Nose
Cone Mounting Assembly over the front crossbar
making sure the Reel Housing Mounting Assembly is
sitting on the rear crossbar. Once the proper position
has been found, flip unit over and tighten the King
Bolts using the ¼ inch Hex Wrench securing the Nose
Cone and Reel Housing Mounting Assemblies in
place. Flip unit back over and place Rack Clamp Feet
underneath front and rear crossbars and secure with
small washer and 2" Rack Clamp Bolt as shown in
Figure 4 (for Thule Xsporter use 2.5" King Bolts)
sure the reel housing is sitting on the rear crossbar
with enough room to mount in the next step. Once
the proper position has been found, flip unit over
and tighten the king bolts securing the Reel Housing
Mounts in place. Flip unit back over and place Rack
Clamp Feet underneath front crossbar and secure
with Small Washer and 2" Rack Clamp Bolt as shown
in Figure 4 (for Thule Xsporter use 2.5" King Bolts)
7. For the T-slot mount make sure one T-slot Bolt is on
each side of the crossbar. Using the Non-Threaded
T-slot Foot, place it under the crossbar and insert
both T-slot Bolts into the corresponding holes in the
foot. Using a ½ inch Wrench screw on T-slot Nuts to
secure unit to crossbar as shown in Figure 5
506-7390