Password Entry - Nuova Simonelli MYTHOS 220 Manuel D'instructions

7.4.10

PASSWORD ENTRY

The new software version includes the possibility to enter a password to prevent access to
programming. Once on the "EDIT PSW" page, it is possible to enter or change a password
by pressing the flashing key
1) Entering a new password; on the "NEW PSW" page, all keys will be flashing and
it is therefore possible to enter a combination, using the flashing keys to create
a sequence. The length of the password in terms of "characters" (keys) entered,
can vary from zero (password disabled) to eight (8). To enter a "character" in the
sequence, it is necessary to press and immediately release the required key; the dis-
play will show an asterisk (*) symbol. To store the sequence, it is necessary to press
and hold down the key
and only the empty page is stored, no password will be used. On the next page,
"CONFIRM PSW" a password confirmation will be requested; proceed as described
above, entering the same sequence, storing it to memory with the
2) Changing a previous password. On the "ENTER PSW" page, it is first necessary
to enter and confirm the previous password before following the instructions provided
in point 1.
Once the password has been entered, it will be requested for access to any programming
function (See Par. 7.4.5 SETTING GRINDING TIMES). Once entered, the sequence needs
to be confirmed with the
If the password entered is not correct, the display will read "PSW ERROR" for about 3 sec-
onds before returning to its previous mode.
There is no limit to the error of entering the password.
If the machine should switch off accidentally, the password will remain stored in the memory
only if after the "store" step has been completed during "CONFIRM PSW".
If the user forgets the password, it is possible to access the programming function using
the "RELEASE CODE": press and hold down (for 10 seconds) the
should switch off accidentally, the password will remain stored in the memory only if after
the "store" step has been completed during "CONFIRM PSW".
If the user forgets the password, it is possible to access the programming function using the
"RELEASE CODE": press and hold down (for 10 seconds) the:
then press the , key to confirm; this will disable the previously set password and make
it possible to access the programming function.
The whole "PASSWORD" function is active for all operating modes; in the "MANUAL" and
"AUTOMATIC" modes it blocks access to all programming. However, in "BARISTA" mode
it is still possible to edit dose times but it is not possible to access counters.
24
. At this point, there are 2 options:
for about three seconds. If the sequence is not entered
key.
EN
key.
If the machine
MYTHOS