Elkron HP375M Manuel D'installation page 13

INSTALLATION
1) Open the siren by release the screws.
2) Slide the cover on one side as shown on
Figure 1.
The siren comes from the factory equipped with
anti-opening protection. anti-removal micro-switch
set-up:
Loosen the screw which keeps the Tamper block
fixed (Fig. 2) and remove it.
Arrange a wall plug on the wall which when the
siren is present will be located at the slot on the
base of the block (Fig. 3).
Then insert the block making it turn so as to insert
its base under the bottom of the siren (Fig. 3) and
then fix it with the screw into the previously
prepared wall plug.
Screw
Fig. 2
3) Fix the siren to the wall using the
rawplugs in the kit, utilising the holes
provided.
A = Wall fixing holes
B = Cable entry hole
C = Lodging for buffer battery
Running
facilitated
embossing.
13/24
Fig. 1
(not supplied)
of connecting
by the
Fig. 3
cable is
fixing holes
HP375M