Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Blue LED flashing
accompanied by
long (1s) beeping
pattern
Blue LED flashing
accompanied by
short (500ms) and
long (1s) alternate
beeping pattern
Four green LEDs
flashing together
accompanied by
long (1s) beeping
pattern
Blue LED flashing
accompanied by
a short (500ms)
short (500ms)
long (1s) beeping
pattern
Blue LED flashing
accompanied
by three short
(500ms) beeping
pattern
Blue LED
periodically
flashing (no
pattern)
Blue LED flashing
every 0.5 seconds
The
environmental
temperature is
too high for the
battery to
operate safely
Incorrect AC
adapter being
used
PAP device
connected
to battery is
incompatible
Incorrect AC
adapter being
used
PAP device
connected
to battery is
incompatible
DC output cable
is damaged
PAP device
connected
to battery is
incompatible
Maximum battery
power output
Battery capacity is
below 5%
Ensure that the battery is placed
where there is no excess heat. Do not
rest the battery on top of radiators or
electronic devices that may emit heat.
Do not attempt to use the battery in
temperatures exceeding 40° C / 104° F
Pilot-12 Lite: use the AC adapter
provided
with
your
DreamStation or Respironics System
One
S60
or
other
power
adapters
(see
Pilot-24 Lite: use the AC adapter
provided with your ResMed S9 or
ResMed AirSense 10 or the Medistrom
AC adapter (see section 2.3).
Ensure that the PAP device you are
using is compatible with the Pilot-12
Lite or Pilot-24 Lite (see sections 1.3
and 2.3 respectively)
Pilot-12 Lite: use the AC adapter provided
with your Respironics DreamStation or
Respironics System One S60 or other
compatible power adapters (see section
1.3)
Pilot-24 Lite: use the AC adapter provided
with your ResMed S9 or ResMed AirSense
10 or the Medistrom AC adapter (see
section 2.3)If problem persists please
contact Medistrom technical support at
1-888-407-4791 (North America), 1-300-
146-358 (Australia) or email support@
medistrom.com
Ensure that the PAP device you are
using is compatible with the Pilot-12
Lite or Pilot-24 Lite (see sections 1.3
and 2.3 respectively)
Ensure that the cable connecting the
Pilot-12 Lite or Pilot-24 Lite to your
compatible PAP device is not damaged
Ensure that the PAP device you are
using is compatible with the Pilot-12
Lite or Pilot-24 Lite (see sections 1.3
and 2.3 respectively)
No action required, the battery is
operating correctly. Depending on
your prescribed pressure, enabled
PAP device features and breathing
rate the battery may reach maximum
power output which is indicated by the
periodically flashing blue LED
Charge the battery as soon as
possible. The battery power level is
critically low. Not charging the battery
for a prolonged period will cause it to
go into Over Discharge State.
Respironics
compatible
section
1.3).
15
Publicité
Table des Matières
