Medistrom Pilot-12 Lite Mode D'emploi page 10

Section 2.5 Pilot-24 Lite Control Panel
1 2 3 4 5 6 7
1. Charge Port
Plug the compatible AC adapter into this port (use the short charging adapter cable if
required). Ensure that the AC adapter is plugged into the mains power outlet. Once the
battery is charging the 4 green Charge Level Indicator Lights will turn on.
2. Multi Function Button
Pressing the button once will show the battery's charge level (if the battery is in Standby
Mode: refer to Stand-by Mode in Section 2.6)
Holding the button for 3 seconds will turn the LED Flashlight On and Off
3. Blue "ON" Indicator Light
The light will shine solid blue once the battery is connected and is sending power to a
compatible PAP device. (If this light is flashing please check the error code in Section 8)
4. Green Charge Level Indicator Lights
When the battery is being charged, the lights will blink, and then shine solid green
showing the level of charge going from Lo to Hi. Refer to Section 8 for a guide to charge
levels.
5. LED Flashlight
Can be turned ON and OFF by holding the Multi Function Button for 3 seconds.
Note: If the Pilot Lite battery is not connected to a device, the flashlight will turn OFF
automatically after 10 minutes, otherwise, the flash light will remain ON.
6. USB Port (5V 2.5A Out)
Can be used to charge handheld devices (please check that the output Voltage and
Amperage is compatible with the device that needs charging via the USB before
connecting). Once connected press the Multi Function Button to turn on the battery.
7. DC Out Port
This port is used to connect a compatible PAP device to the battery.
Section 2.6 Pilot-24 Lite Setup
ATTENTION: No power adapters are included with your Pilot-24 Lite Battery and
Backup Power Supply. Please refer to section 2.2 PAP Device Compatibility on
information how to charge your battery.
Using Pilot-24 Lite as a Backup Power Supply for PAP devices
10