Top Exit - Napoleon B42NTR Instructions D'installation Et D'opération

3.13

TOP EXIT

FAILURE TO INSTALL THE COVER PLATE AND GASKET WILL CAUSE THE APPLIANCE TO
FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
NOTE: This appliance has been factory shipped as a rear vent.
A. Remove the safety screen and glass front, refer to " SAFETY SCREEN / DOOR REMOVAL AND
INSTALLATION" section.
B. Remove the contents from the fi rebox and set aside,
you will need the exhaust collar from the top of the log
carton.
C. To ease assembly, remove the four hex head screws
securing the defl ector from inside the top front of the
fi rebox.
D. Remove the single screw from the outer cover on the
back of the appliance.
E. Remove the four screws on the 7" (178mm) intake
collar assembly; set the intake collar and gasket aside.
Careful not to damage gasket.
F. Remove the single screw from the outer cover with
knockout intact, on the top of the appliance and set
aside.
G. Remove the inner cover plate and gasket by removing
the four screws. Reinstall the inner cover plate and
gasket onto the back of the appliance.
H. Take the outer cover (with knockout intact) and secure
onto the back of the appliance.
I. Remove and discard the 1 1/2" thick batt of insulation
from the top opening.
J. Place the 7" (178mm) intake collar
and gasket onto the top of the
appliance and secure with the four
screws.
K. Reinstall the outer cover (without
knock out) over the 7" (178mm)
exhaust collar assembly and secure.
L. From inside the fi rebox, install the 4"
(102mm) exhaust collar up through the top of the fi rebox and secure with the the four hex head 3/8"
thread cutting screws. NOTE: Do not overtighten. The gasket needs only to be snug against the
fi rebox.
M. Reattach the top defl ector, log set, glass door and safety screen.
WARNING
!
DEFLECTOR
F
I
E
GASKET
INTAKE COLLAR
ASSEMBLY
OUTER COVER
INNER
COVERPLATE
G
OUTER
COVER
(with knockout)
EXHAUST FLUE COLLAR
W415-1293 / B / 05.25.16
25
EN
E
D
GASKET