Suspending The Lift From The Rail; Hand Control - human care Altair Manuel De L'utilisateur

Suspending the lift from the rail

Place the lift on a suitable surface. Feed out
enough of the belt by pulling gently on the
hook on the lift belt (2) while at the same time
keeping the Down button on the hand control
or on the control panel of the lift pressed in.
Hook onto the hook on the distance strap
hanging from the rail roller diagonally from
above (see fig)
Switch on at the mains and the lift is ready for
use.

Hand control

The covers for the USB input and
o
the charging input must be closed
for the hand control's water protection
(IPX5) to be valid.
www.humancaregroup.com
The hand control is equipped with an Up
1 button (1) and a Down button (2) for raising
and lowering the lift.
2
When the lift is loaded with less than approx.
40 kg it can be run at two speeds. If the Up
or Down button is pressed for longer than 3
seconds, the lift will run in the faster mode. If
the lift is loaded with more than approx. 40 kg
it will only run in the slower mode.
On the short side of the hand control there
is an input for charging the lift and an input
(mini-USB) for communicating with the lift.
2
ENG
ENG
25