Erasing Memory/Changing User Profile; Guest Mode - Oregon Scientific GR101H Manuel D'utilisation

ERASING MEMORY/CHANGING USER
PROFILE
If you change your birthdate or height
information in your User Profile, the
previously stored measurements in
memory may no longer be applicable.
So, when you make any modifications to
the User Profile, the Remote Monitor will
ask you if you would like to erase your
previously stored measurements.
NOTE
If you change the gender of a User
Profile, the previous measurements in
that profile will automatically be deleted.
Press / to select
or to keep existing memory. Press SET
to confirm.

Guest Mode

With the Guest Mode, you can
quickly measure your weight and
BMI without needing to set up a User
Profile. However, in this mode, your
measurements will not be stored.
1. Press Guest/Weight. Once the
Reception icon
Scale's LED Indicator is blank, the
Remote Monitor is ready to receive
your weight information.
to erase memory,
blinks and the
6
2. Follow Steps 3 and 4 of the USER
PROFILE MEASUREMENTS
section.
NOTE
You can choose to skip the next set
of instructions in this section if you do not
want to measure your Body Fat and Body
Water levels.
3. Once the green LED stops blinking,
the Remote Monitor will prompt you
for:
NOTE
Press /
values of each setting. Press SET
to confirm. Press
anytime.
a.
Gender:
b. Birth Month
c. Birth Year
d. Height:
• In centimetre (cm) if kg
(kilogram) weight unit was
selected.
• In feet and inches if lb
(pound) or st-lb (stone)
weight unit was selected.
4. When completed, your Body Fat and
Body Water measurements will be
alternately displayed on the Remote
Monitor.
to adjust the
to exit
Male / Female
icon appears