Mains Supply; Operation; Check Before Switching On; Switching On/Off - Lux Tools HD-130/1800 Notice Originale

Hochdruckreiniger_389841.book Seite 37 Montag, 19. November 2012 5:15 17
• a fabric-reinforced hose with a minimum
diameter of 13 mm (½")
– Insert the water hose into the plug-in cou-
pling and connect to the water supply.

Mains supply

– Ensure that the on/off switch (18) is at [0].
– Open the water inlet.
– Insert the mains plug into the socket.

Operation

► P. 5, item 13 – ► P. 5, item 15

Check before switching on!

Check the safe condition of the machine:
– Check it for visual defects.
– Check that all parts of the machine have
been securely fitted.
– Check if the water connector and the
high-pressure pipes are tight.
Water inlet
– Open the water inlet.
– Retract the switch-on safety lock (19).
– Actuate the lever (20) of the spray gun
until a water jet escapes continually.
NOTICE!
Risk of machine damage!
Never operate the machine without
water inlet as dry running may dam-
age the pump. Use a water filter if the
inlet water is contaminated.

Switching on/off

– To switch the machine on, set the On/Off
switch (18) to [1].
– To switch the machine off, set the On/Off
switch (18) to [0].
Switching on the water jet
DANGER!
Risk of fatal injury!
Use special care when cleaning
tyres. Vehicle tyres/tyre valves may
become damaged or burst when
handled improperly. First signs of
damage included discolourations on
the tyre. Damaged vehicle tyres/tyre
valves pose a life-threatening risk.
Keep the jet at a distance of at least
30 cm!
DANGER!
Risk of fatal injury!
The high-pressure jet may be dan-
gerous when handled improperly.
The jet may not be directed towards
living beings (persons, animals), live
equipment or the machine itself.
– Hold the hand-held spray gun and the jet
tube firmly with both hands. Be aware of
the recoil when switching on the high-
pressure jet.
– Retract the switch-on safety lock (19).
– Actuate lever (20) of the spray gun
The high-pressure pump starts running as
soon as you operate the hand-held spray
gun.
The high-pressure pump stops running as
soon as you release the lever on the hand-
held spray gun.
Switch the machine off when interrupting
your work for extended periods of time.
Adjusting the high-pressure water jet
– Rotate the nozzle (21) clockwise: spot-
type jet;
– Rotate the nozzle (21) anticlockwise: fan-
shaped jet;
Use in combination with cleaning agents
► P. 5, item 16, ► P. 5, item 17
Note:
add cleaning agents only in low-
pressure mode.
– Switch the machine off.
GB
37