Battery Check - Plugwise TOM Manuel D'installation

Battery check

Quickly press and release the button.
The LED will flash for 3 seconds if the
batteries are running empty.
Overrule the set temperature
with TOM
Press the button for 5 seconds and
release.
The LED will blink for 2 seconds:
• Orange-green if TOM will fully close,
and as such block the radiator from
heating.
• Orange-red if TOM will fully open and
so allows the radiator to heat up.
TOM will continue normal operation as
soon as a new change in the schedule
has been made or a new target
temperature is set.
Remove TOM from the network
It is possible to remove TOM from the
network:
Press the button for 3 seconds and
release.
Within 1 second, press again the button
for 3 seconds and release.
Within 1 second, press the button for
10 seconds and release.
15 | English
After you have released the button, the LED
will burn solid red for 5 seconds: TOM has
left the network.
Recalibrate
Calibration is performed automatically
during the start up. It can also be forced:
Press the button for 10 seconds and
release.
Within 1 second, press the button again
for 10 seconds and release,
Within 1 second, press the button for 3
seconds and release.
The LED will blink orange slowly until the
calibration is complete.
After completion, the LED will blink orange-
green for 5 seconds if the calibration was
successful.
In case the calibration failed, the LED will
blink orange-red for 5 seconds.
Calibration will fail if TOM is not
mounted on to the radiator, as TOM
cannot determine its mounting point.
Button sequence not
recognized
When TOM does not understand the
button pattern, the LED will flash red for 0,5
seconds.