Safety Information - Cadac SAFARI CHEF 6547F Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For Outdoor use only! This appliance may not be used in an exterior enclosed balcony, porch or entertainment area.
Read these instructions carefully so as to familiarise yourself with the appliance before use.
1. Introduction
?
Use Outdoors Only.
?
This Appliance complies with BS EN 498:2012.
Appliance category: I
3+ (28-30/37
?
For use with Butane using a 28-30 mbar supply pressure regulator or Propane using a 37mbar supply pressure
regulator.
Appliance category: I
(30)
3 B/P
?
For use with Butane / Propane gas or its mixtures at a regulated supply pressure of 30mBar.
?
This product is factory fitted with a 71 jet.
Nominal usage : Butane 140 grams per hour, gross nominal heat input 1.92 kW.
?
This appliance shall only be used with an approved hose and regulator, connected to:
a) a CADAC 445g or 220g Disposable Cartridge, Model CA445 or CA220 or the same type threaded re-sealable
cartridge complying with EN 417, or
b) a refillable cylinder complying with the local regulation in force.
?
The gas cartridge/refillable cylinder is to be used only in the upright position.

2. Safety Information

?
The hose must be checked for wear or damage before every use and before connecting to the gas container.
?
Do not use the appliance if it has a damaged or worn hose. Replace it.
?
Do not use an appliance that is leaking, damaged or which does not operate properly.
?
Ensure the appliance is used away from flammable materials. Minimum safe distances are: Above the appliance 1.2m.
At the rear and sides 600mm. (See Fig. 1)
?
Ensure that the gas container is fitted or changed outdoors, away from any sources of ignition, such as naked flames,
pilots, electric fires and away from other people.
?
Keep gas containers away from heat and flame. Do not place on a stove or any other hot surface.
?
Ensure that the assembled product is stable and does not rock.
?
In the event of light back (where the flame burns back and ignites at the jet), immediately turn off the gas supply by
closing the control valve on the gas container and then the appliance valve. After the flame is extinguished remove the
regulator and check the condition of its seal. Replace the seal, if in doubt. Re-light the appliance as described in
section 4 below. Should the flame persistently light back, return the product to your authorised CADAC repair agent.
?
If there is a leak on your appliance (smell of gas), take it outside immediately into a flame free location where the leak
may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks
using a flame; use soapy water.
?
The correct way is to smear the joints e.g. where the stem fits into the cylinder, with soapy water.
?
If bubbles form, then there is a gas leak. Immediately turn off the gas supply by closing the control valve on the gas
container and then the appliance valve. Check that all the connections are properly fitted. Re-check with soapy water.
?
If a gas leak persists, return the product to your CADAC dealer for inspection / repair.
?
Use Outdoors Only.
CAUTION
IMPORTANT
Retain these instructions for future reference.
(BE, ES, FR, IE, IT, PT, GB, CH)
)
(DK, FI, NO, NL, SE, AT, DE)
GB
Fig.1

Publicité

Table des Matières
loading

Table des Matières