Evolution TWISTER Instructions Originales page 4

(1.6)
Note: The vibration measurement was made
under standard conditions in accordance with:
EN 62841-1+AC:2015 and EN 62841-2-10:2017
in EU market and BS EN 62841-1+AC:2015 and
BS EN 62841-2-10:2017 in UK market
The declared vibration total value(s) and the
declared noise emission value(s) has been
measured in accordance with a standard test
method and may be used for comparing one
tool with another.
The declared vibration total value(s) and the
declared noise emission value(s) may also be
used in a preliminary assessment of exposure.
(1.7)
VIBRATION
WARNING: When using this machine the
operator can be exposed to high levels
of vibration transmitted to the hand and
arm. It is possible that the operator could
develop "Vibration white finger disease"
(Raynaud syndrome). This condition
can reduce the sensitivity of the hand
to temperature as well as producing
general numbness. Prolonged or regular
users of this machine should monitor
the condition of their hands and fingers
closely. If any of the symptoms become
evident, seek immediate medical advice.
• The measurement and assessment of
human exposure to hand-transmitted
vibration in the workplace is given in:
EN 62841-1+AC:2015 and EN 62841-2-10:2017
in EU market and BS EN 62841-1+AC:2015
and BS EN 62841-2-10:2017 in UK market
• Many factors can influence the actual
vibration level during operation e.g. the
work surfaces condition and orientation
and the type and condition of the machine
being used. Before each use, such factors
should be assessed, and where possible
appropriate working practices adopted.
Managing these factors can help reduce
the effects of vibration:
www.evolutionpowertools.com
Handling
• Handle the machine with care,
allowing the machine to do the work.
• Avoid using excessive physical effort on
any of the machines controls.
• Consider your security and stability, and
the orientation of the machine during use.
Work Surface
• Consider the work surface material;
its condition, density, strength,
rigidity and orientation.
WARNING: The vibration emission during
actual use of the power tool can differ from
the declared total value depending on the
ways in which the tool is used. The need
to identify safety measures and to protect
the operator are based on an estimation
of exposure in the actual conditions of use
(taking account of all parts of the operating
cycle, such as the times the tool is switched
off, when it is running idle, in addition to
trigger time).
(1.8)
LABELS & SYMBOLS
WARNING: Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools
for replacement labels.
Note: All or some of the following symbols
may appear in the manual or on the product.
4