Evolution TWISTER Instructions Originales page 12

OPERATING INSTRUCTIONS
The On/Off Trigger Switch (Fig. 4a)
Note: The Trigger Switch is ergonomically located on the
underside of the RH handle.
Note: For continuous operation, and to provide operator
comfort, the trigger switch is fitted with a 'lock-on' button.
(Fig. 4b)
• For operation press the lock-on button, then squeeze the
trigger switch (the trigger switch will not move if the lock-on
button is not pressed first).
• For continuous operation press the lock-on button in further
whilst still pressing the trigger switch.
• To switch the machine off from continuous operation
gently squeeze the trigger switch and then release.
Speed Control
The Speed Control Adjustment Wheel (Fig. 5) is ergonomically
located on the inside of the LH handle where it can be easily
accessed by the thumb of a skilled operator.
Turning the Speed Control Adjustment Wheel alters the speed
of the motor through the range of approximately 250 – 700
rotations per minute (no load speed).
MIXING OPERATIONS
WARNING: This machine requires two (2) handed operation.
WARNING: The operator must observe all of the Safety
Instructions as outlined in this Instruction Manual. Failure to do
so could result in an increased risk of an accident or injury to
the operator.
• Position the Mixing Tub on a horizontal, stable and
secure surface.
• Place the materials to be mixed in the Mixing Tub in
accordance with the recommendations provided by the
manufacturer of the materials.
• Check the Twister Unit and particularly the security of the
attached Mixing Paddle.
• Place the Mixing Paddle in the Mixing Tub.
• Adopt a secure stance holding the Twister Unit with both hands.
• With the lowest speed setting selected depress the Trigger
Switch to start the motor.
www.evolutionpowertools.com
Fig. 4a + 4b
Fig. 5
12
(a)
(b)