Environmental Protection - Evolution TWISTER Instructions Originales

www.evolutionpowertools.com
• Be prepared for the impact of the torque
forces especially on 'start up'.
• Adjust the speed of the motor to give
optimum mixing performance.
• During mixing, guide the Mixing Paddle
around the Mixing Tub.
• Continue mixing until the required
material consistency is achieved.
• Release the Trigger Switch and allow the
Mixing Paddle to come to a complete stop.
• Remove the Mixing Paddle from the
Mixing Tub.
WARNING: If the Mixing Paddle comes into
contact with the bottom or side(s) of the
Mixing Tub during mixing operations
'kick back' can be experienced.
MAINTENANCE
Note: Any maintenance must be carried
out with the machine switched off and
disconnected from the mains power supply.
Clean the Twister Motor Unit and the Mixing
Paddle immediately after use. Follow the
advice given by the material manufacturers
regarding equipment cleaning and the
disposal of surplus material.
All motor bearings in this machine are
lubricated for life. No further lubrication is
required. The threads on the Mixing Paddle
and in the machines arbor should be given an
occasional coating of light machine oil.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by
inserting pointed objects through openings
in the machines casings etc. The machines air
vents should be cleaned using compressed
dry air.
Excessive sparking may indicate the presence of
dirt in the motor or worn out carbon brushes.
(>6.2)
If this is suspected have the machine
serviced and the brushes replaced
by a qualified technician. (<6.2)
(6.4)

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice
13
EN