Getting Started - Evolution TWISTER Instructions Originales

www.evolutionpowertools.com
Fig. 1
Fig. 2
Fig. 3

GETTING STARTED

ASSEMBLY
The Mixing Paddle
Note: The Evolution Twister is supplied with a two (2) piece
Mixing Paddle.
The two pieces of the Mixing Paddle simply screw together (Fig. 1)
and should be securely tightened using the spanner supplied.
The Mixing Paddle to the Twister Motor Unit
Note: The machines arbor (Fig. 2) projects from the
Twister Motor Unit, and has two (2) flats machined on it to
accommodate the supplied spanner.
The internal hole in the arbor contains a Ø14 mm thread. This
internal thread matches the external Ø14 mm thread found on
the Mixing Paddle shaft.
The Mixing Paddle should be screwed into the machines arbor
and securely tightened.
Note: The machines arbor should be held with a spanner to
prevent it from rotating when the Mixing Paddle is attached
to the Twister Motor Unit.
TEMPORY STORAGE
Ensure that when the Twister is placed on a work-surface etc
the Motor Unit is as shown in (Fig. 3) with the power cord
emerging vertically from the handle.
11
EN