Important Safety Instructions; Agency Approvals; About The X2; General Specifications - BriskHeat X2 Manuel D'instructions

IMPORTANT SAFETY INSTRUCTIONS

DANGER
A person who has not read and
understood all operating
Instructions is not qualified to
operate this product.
DANGER

Do not immerse or spray any component of the
control system with liquid.

Keep volatile or combustible material away from
controller when in use.

Keep sharp metal objects away from heater.

Use controller only ordinary
(non-hazardous) locations
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:

Only qualified personnel are allowed to connect
electrical wiring.

All electrical wiring must follow local electrical
codes and NEC Article 427.

The person who performs the final installation /
wiring must be qualified for this work.

The end-user is responsible for providing a
suitable disconnect device.

The end-user is responsible for providing a
suitable over-current protection device. It is highly
recommended that a ground-fault circuit breaker
be used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
®
© BriskHeat Corporation. All rights reserved.
X2 Benchtop
PID Digital Temperature Controller

Agency Approvals

Approvals valid only when installed in accordance with
all applicable instructions, codes, and regulations.
CAUTION

Inspect all components before use.

Do not repair damaged or faulty controller

Do not crush or apply severe physical stress on
any component of system, including cord
assembly.

Unplug control and heating system when not in
use.
Failure to observe these warnings may result in personal
injury or damage to the heater.
DANGER
Do not use Set Point 2 as the sole alarm where
personal injury or damage may be caused by equipment
failure.
3
WARNING
Read and understand this entire manual before operating this controller.

ABOUT THE X2

General Specifications


For indoor general purpose applications

Portable, plug-and-play design

PID Control, automatic tuning of PID parameters

Simple three-key user control

Operating temperature range:

32 to 1400°F (0 to 760°C) for J/K Thermocouple

-273 to 750°F (-200 to 400°C) for Pt100 / RTD-2

Programmable in either °C or °F (Default set point is 0°C).

Type J or K thermocouple mini connector input

Thermocouple sold separately or RTD (Pt100)

Operating Voltage:

100-130VAC, 50 to 60hz, +/-10% maximum permitted fluctuation

200-240VAC, 50 to 60hz, +/-10% maximum permitted fluctuation

User Programmable alarm types including latching options

Programmable security lock levels

Fused input

Environmental temperature range:

32-130°F (0-50°C)

80% maximum humidity

Altitude:

Up to 2000M

Sensor break protection with average output option which allows process to continue
heating

Auto / manual control ability

Includes a mating AMP Mate-N-Lock power connector to be added to heater

Output power cords with different plug receptacles sold separately. Contact
®
BriskHeat at 1-800-848-7673 or 1-614-294-3376 for more information.
Note: Check Part Number on Control to confirm sensor type and voltage match your
requirements and supply. Refer to the "Part Number Matrix and Accessories" selection for details.
®
© BriskHeat Corporation. All rights reserved.
X2 Benchtop
PID Digital Temperature Controller
4