Crane Settings, Cv- List - Roco EDK 750 Manuel

▪ Crane Settings
The Sounddecoder has been optimally adjusted to this crane. You can still adapt numerous
ration Variable – or register) can be amended.
Please check before each programming if this is really necessary. Incorrect settings can result in
the decoder not reacting correctly.
The decoder is preprogrammed with 28/128 speed steps at the factory for a high level of com-
fort. This means that it can be used together with all of the modern DCC (multiMAUS) and
Motorola ® control devices.
not be replaced with a decoder which is available from a retailer.
If the crane is to be reprogrammed, only the crane is to be on the programming track.
▪ CV-list
CV Name
1 Address (= short address)
2
3
4
5
6
Value 1 corresponds to 1/3 of Vmax. (CV 5)
7 Decoder Version Number (only read! Readable only on
Important! Please note when using the multiMAUS in
order to achieve CVs greater than CV255: when underta-
king a short-term programming of CV7, only the subse-
quent programming access with the value 10 is increa-
CV266 for example).
CV places.
8
908
readable)
17+ Long address (requirement: corresponding CV29 long
18 address setting is activated)
29 Settings
266
44
44
(lowest creeping speed)
(from standstill to maximum speed)
(from maximum speed to stand-still)
(at medium running step)
(meaning CV166 then accesses
Value
01 – 99
01 – 255
00 – 255
00 – 255
00 – 255
00 – 255
(With 08 = Reset
100 – 9999
00 – 255
-
Value
3
1
10
5
255
1
145
10
70