Switching On And Off - Mafell S 35 M Traduction De La Notice D'emploi Originale

5.1 Switching on and off

Switch positions 1 (Fig. 1)

Put plug in socket outlet
>0< = Dust extractor switched off
>I< = Dust extractor switched on without
vibration function
>IR< = Dust extractor
automatic vibration function
>AR< = Dust extractor
automatic vibration function
Only when the tool is switched on will
the dust
automatically.
After switching off the tool, the dust
extractor will run on for approx. 10 sec.;
this is to prevent any residual amounts
remaining in the hose.

Set dust extractor to switch position >0<.

Pull power plug when finished.

For storage purposes, fix the suction tube on the
container backplate by inserting it in the
accessory depot*.

The hose ends can be stuck together to prevent
any dirt particles from escaping.
Preselection switch for minimum
volume flow signal (horn and
light) on dust extractors class
"M".
In mode >AR< and >IR, the following setting is
made, depending on the hose diameter:
Hose inside diameter
Ø 49 mm
Ø 35 mm
Ø 27 mm
Ø 21 mm
For options Ø 27 mm and Ø 21 mm, the speed is
reduced.
The dust extractor S 35 M is equipped with an electric
suction force regulator. The turning knob 2 can be
switched on with
on standby with
extractor switch
Flow rate
70 m³/h
70 m³/h
40 m³/h
20 m³/h
used to adapt the suction power to the material to be
vacuumed.

Put power plug of the dust extractor into the
socket outlet.

Place switch for normal mode without vibration
function to "I", for normal mode with vibration
function to "IR" or for standby mode to "AR".
Dust extractor is ready for extraction.


After extraction, put switch to "O".
Dust extractor is switched off


Pull power plug of the dust extractor from the
socket outlet.
on

Clear away mains cable.

Remove electric tool.
The socket outlet 4 is intended for connection of an
electric tool (IR/AR mode).
To avoid excessive start-up peaks, the dust extractor
is equipped with a starting current limit (soft start).
5.1.1 Permanent filter cleaning
The dust extractor is equipped with an electro-magnet
filter cleaning system, that can be used to shake
adhering dust off the folded filter cartridges. The
folded filter cartridges are cleaned alternatively in
succession so that continuous working is guaranteed.
- Constant fill level monitoring of the filters by
differential pressure measurement for absolutely
accurate need-controlled filter cleaning during
operation.
- This guarantees a constantly high air flow during
operation, even for critical types of dust.
-23-