Rane ONE Guide D'utilisation page 6

10. Beat: Turn this knob to set the Time Division for the selected effects.
11. Tap: Press this button multiple times at the desired tempo to manually set the BPM rate for
beat-tempo effects, per channel.
12. FX 1–6: Press one of these buttons to activate or deactivate the corresponding software effect
shown in the Serato software FX 1 and FX 2. Pressing the buttons will activate one effect at a
time, or pressing and holding the buttons will activate multiple effects at once.
13. Effects Toggle: Move this toggle switch away from you to activate the software effects—the toggle
will latch to that position. Pull the toggle back to the center position to deactivate the effects.
Pull and hold this toggle toward you to activate the software effects momentarily, and release
the toggle to deactivate the effects—the toggle will return to the center position.
14. Deck Cue: Press this button to send this deck's pre-fader signal to the cue channel for
monitoring. When engaged, the button will be lit. To cue multiple channels simultaneously,
press the Deck Cue buttons for both decks.
15. Deck Fader: Move this fader to adjust the volume level of the corresponding deck.
16. Crossfader: Move this fader to mix between the decks.
17. Search: The length of this strip represents the length of the entire track. Place your finger on a
point along this sensor to jump to that point in the track. The LEDs above the strip indicate the
approximate location of the playhead in the track.
18. Scroll/Load / Instant Doubles: Turn this knob to browse through lists and press it to select an
item or load the currently selected track to the deck.
Press this knob twice quickly to load the same track to both decks ("instant doubles").
19. Back / Load Prep: Press this button to view the previous screen in the software.
Hold Shift and press this button to load the currently selected track to the Prepare Crate.
20. High Torque Direct Drive Platter: A powerful motor turns this aluminum platter with speed
position dots. Use the Motor Torque switch on the rear panel to adjust the torque of the platters
Note: The platter itself should not be held in position for sustained periods while powered to
rotate.
21. Control Disc with Slipmat: This 7.2" (18.2 cm) disc controls the audio playhead in your DJ
software. Place the included slipmat under the Control Disc (or a different slipmat can be
used, if preferred).
Note: The Control Disc can be user replaced by attaching the Quick Release Adapter to your
own modified disc. The replacement disc must have three 6 mm holes, and the included disc
should be used as a reference.
22. Quick Release Adapter: This secures the Control Disc to the platter. It comes attached to
the top of the Control Disc. To remove the Control Disc or slipmat from the platter, hold in the
button on the side of the Quick Release Adapter while lifting the disc off the spindle. After
placing the disc back on the spindle, pinch the top of the spindle while slowly rotating the disc
until you hear it click. It locks when the groove in the spindle lines up directly opposite to the
button on the side of the Quick Release Adapter.
23. Stop Time: Controls the rate at which the platter slows to a complete stop ("brake time").
24. Slip / Motor Off: Press this button to enable or disable Slip Mode. In Slip Mode, you can jump
to Hot Cue Points, trigger Loop Rolls, or use the platters, while the track's timeline continues. In
other words, when you stop the action, the track will resume normal playback from where it
would have been if you had never done anything (i.e., as if the track had been playing forward
the whole time).
Press and hold Shift and press this button to activate or deactivate the corresponding platter's
motor. This will not affect the track's playback.
6