YORKVILLE Traynor DG65D Guide De L'utilisateur page 6

The ¼-inch T.R.S. Preamp Out jack can also be
used as a direct line out. The -10dBu output is ideal
for most guitar effects pedals and professional signal
processors. You can also use this output to slave the
DG65 with another guitar amplifier by plugging into the
Amp In jack of the slave amplifier.
The ¼-inch T.R.S. Amp In jack accepts an input
signal that is passed to the power amplifier, so it can
be used as a power amp in. And, since the Master
control section affects the Amp In signal, you can use
Contour and Reverb to further shape your tone.
Footswitch Jack (Channel Select/Boost)
When connected, the footswitch pedal is the
exclusive control for the Channel Select and Boost
functions, bypassing the switches on the DG65's
control panel. It features dual-latching switches,
each with a separate LED indicator.
Footswitch-induced noise is never an issue. The
switching is accomplished with internal FET's so there is
no audio flowing through the footswitch cable. The DG65 is
DG65D
Cabinet Program Power (Watts)
Cabinet Impedance (ohms)
Power @ min. impedance (Watts)
Minimum Impedance (ohms)
Burst Power - 2 cycle
Speaker Configuration - LF (Size / Power)
Input Channels
Channel 1 - inputs
Channel 1 - controls
Channel 1 - switches
Channel 2 - inputs
Channel 2 - controls
Channel 2 - switches
Channel Switching
Master Volume Control
Main Tone Controls
Input Sensitivity (mV)
Master Outputs
Line Out (type / configuration)
Line Out Sensitivity (Vrms)
Effects Volume
Effects Loop / Location
Effects Footswitch / Function
Effects Return Sensitivity (Vrms)
Internal Reverb / Effects
LED Indicators
External speaker output / location
Headphone Jack
Other Features
Dimensions (DWH, inches)
Dimensions (DWH, cm)
Weight (lbs / kg)
23
S p ecifications
Type Solid-State Guitar Amplifier
65
8
65
4
85-watts
12 inch / 75 Watts
Hi / Lo
1/4 inch phone
Gain, Volume, Treble, Bass, Middle
Boost
Shares ch 1 input
Gain, Volume, Treble, Bass, Middle
Bright
Yes / Footswitchable
Yes
Contour
20
Preamp Out / Headphone Out
1/4 inch TRS / Rear (Effects Send)
300mV
Reverb / Effects
Post Preamp / Rear
Yes / Channel Select, Boost
300mV
16 Preset DSP, Seperate Digital Reverb
Channel Select, Boost, Power
Protection Short Circuit, Thermal
1/4-inch, Rear / Internal Speaker Defeat Switch
Yes / Front Panel / Dyna-Sound Speaker Emulation
North American Made
3-Stage Dyanamic Tube Emulation
Transconductance Power Amplifier for further tube
All Plywood Contruction
Perforated Steel Grille
10 x 23.5 x 18
25 x 60 x 46
40 / 18
compatible with most aftermarket latching dual-footswitch
pedals although we do recommend the Traynor TFS-2B
latching dual-footswitch, with 10-foot cable (included).
Rev /EFX Defeat Jack (DG65D) or Reverb (DG65R)
Connecting a footswitch to the rear mounted Rev /
EFX defeat jack (Reverb on the DG65R) can defeat
the internal effects. The included footswitch can
be used for this purpose. Again, since switching is
accomplished using internal FET's, no audio is flowing
through the footswitch cable and noise is not an issue.
External Speaker Jack and Internal Speaker
Defeat Switch
24 25
The chassis mounted ¼-inch jack allows convenient
connection of an 8-ohm external speaker cabinet. If you
disconnect the internal 12-inch Eminence Red Coat®
speaker by depressing the Internal Speaker Defeat
switch, you can connect up to two 8-ohm external
cabinets (minimum speaker load of 4-ohms).
DG65R
Cabinet Program Power (Watts)
Cabinet Impedance (ohms)
Power @ min. impedance (Watts)
Minimum Impedance (ohms)
Burst Power - 2 cycle
Speaker Configuration - LF (Size / Power)
Input Channels
Channel 1 - inputs
Channel 1 - controls
Channel 1 - switches
Channel 2 - inputs
Channel 2 - controls
Channel 2 - switches
Channel Switching
Master Volume Control
Main Tone Controls
Input Sensitivity (mV)
Master Outputs
Line Out (type / configuration)
Line Out Sensitivity (Vrms)
Effects Volume
Effects Loop / Location
Effects Footswitch / Function
Effects Return Sensitivity (Vrms)
Internal Reverb / Effects
LED Indicators
External speaker output / location
Headphone Jack
Other Features
Dimensions (DWH, inches)
Dimensions (DWH, cm)
Weight (lbs / kg)
4
22
S p ecifications
Solid-State Guitar Amplifier
Type
65
8
65
4
85-watts
12 inch / 75 Watts
Hi / Lo
1/4 inch phone
Gain, Volume, Treble, Bass, Middle
Boost
Shares ch 1 input
Gain, Volume, Treble, Bass, Middle
Bright
Yes / Footswitchable
Yes
Contour
20
Preamp Out / Headphone Out
1/4 inch TRS / Rear (Effects Send)
300mV
Reverb
Post Preamp / Rear
Yes / Channel Select, Boost
300mV
Accutronics Spring Reverb
Channel Select, Boost, Power
Short Circuit, Thermal
Protection
1/4-inch, Rear / Internal Speaker Defeat Switch
Yes / Front Panel / Dyna-Sound Speaker Emulation
North American Made
3-Stage Dyanamic Tube Emulation
Transconductance Power Amplifier for further tube
All Plywood Contruction
Perforated Steel Grille
10 x 23.5 x 18
25 x 60 x 46
40 / 18