EN
BR 05
GENERAL USE
BR-CAL.321/322 SELF-WINDING MOVEMENTS
Starting the watch
When the watch has stopped (crown in position 0): unscrew the crown (turn anticlockwise) to position 1. Wind
0 1
the movement by turning the crown clockwise. After approximately 40 rotations, the watch is fully wound (the
winding mechanism does not have a stop to prevent overwinding). The power reserve is approximately 40 hours
when fully wound. When the watch is worn , the automatic mechanism will wind the movement.
watch is set, to ensure perfect water resistance, screw the crown back into position 0. Never operate the crown
underwater.
Setting the date
Quick setting
0
1
2
0 1
0 1
Crown in position 2: unscrew and pull
the crown out to position 2 and set the
0
1
2
3
date by turning the crown anticlockwise.
: as with all mechanical watches
NOTE
with a date function, quickset date set-
ting MUST NOT UNDER ANY CIRCUM-
STANCES be carried out between the
times of 9 PM (21.00) and 3 AM (3.00).
Setting the time
Models with date
0
1
2
0
1
2
3
0
1
2
Unscrew the crown then pull it out to
position 3. The seconds hand will stop,
enabling the time to be set to the near-
est second. Set the time by rotating the
crown in the required direction.
0
1
2
Bell & Ross watches have a power reserve of approximately 40 hours.
Power reserve.
0
1
2
0
1
2
3
0
1
2
4
0 1
Slow setting
0
1
2
3
0
1
2
Crown in position 3: to ensure the date
changes at midnight rather than noon, it
is recommended to set the date by adjust-
ing the hands of the watch. Unscrew and
pull the crown out to position 3 and turn
the hands until the date changes. Then set
the precise time.
Models without date
0
1
2
Unscrew the crown then pull it out to
position 2. The seconds hand will stop,
enabling you to set the time to the near-
est second. Set the time by rotating the
crown in the required direction.
0
1
2
Once the
NOTE
:
1
0
2