Automatic Call Acceptance; Rejecting A Call - SilverCrest SBTF 10 C2 Mode D'emploi

Accepting and ending a call
GB
When you receive a call the LED status indicator
IE
and you hear a call tone from the hands-free appliance.
If the call signal in your mobile phone is switched off, the
ringing tone is nonetheless sounded via the hands-free
appliance.
Press the multi-function button
to accept the call.
Press the multi-function button
to terminate the accepted call.
You can also accept and terminate the call over the
mobile telephone.

Automatic call acceptance

If automatic call acceptance is activated in the mobile tel-
ephone, it accepts the incoming call after a determined time
period and then passes it on to the hands-free appliance. Fur-
ther information regarding automatic call acceptance is to be
found in the operating instructions for your mobile telephone.

Rejecting a call

Press the multi-function button
reject an incoming telephone call.
Adjusting the volume of the hands-free appliance
You can adjust the sound volume level of the hands free
device with the +/- buttons
During a conversation, press the + or - button
the desired volume level is set. A high-pitched beep
signals that you have reached maximum volume;
a low-pitched beep signals that you have reached
minimum volume.
12
shortly once,
shortly once,
for 3 seconds to
.
blinks
until
SBTF 10 C2