English - Wurth Master HBS 533 Traduction De La Notice Originale

OBJ_BUCH-1105-001.book Page 10 Tuesday, December 8, 2009 11:03 AM
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious
injury.
❏ See data sheet for further safety warnings
and instructions.
❏ Hold power tool by insulated gripping
surfaces, because the belt may contact its
own cord. Contact a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
❏ Use the machine only for dry sanding. Pen-
etration of water into the machine increases the
risk of an electric shock.
❏ Apply the machine to the workpiece only
when switched on and switch the machine
off only after it has been lifted away from
the workpiece. The power tool can move sud-
denly.
❏ Never touch the running sanding belt.
Danger of injury.
❏ Pay attention that no persons are put at
risk through sparking. Remove any com-
bustible materials in the vicinity. Sparking
occurs when sanding metal materials.
❏ Do not use worn, torn or heavily clogged
sanding belts. Damaged sanding belts can
tear apart, be thrown from the machine and
injure somebody.
❏ Caution, fire hazard! Avoid overheating
the object being sanded as well as the
sander. Always empty the dust collector
before taking breaks. In unfavourable condi-
tions, e. g., when sparks emit from sanding met-
als, sanding debris in the dust bag, micro filter or
Intended Use
The machine is intended for dry sanding–with high
removal capacity–of wood, plastic, metal, filler as
well as varnished surfaces.
For damage caused by usage other than intended,
the user is responsible.
10–English
Safety Warnings for Sander
paper sack (or in the filter sack or filter of the vac-
uum cleaner) can self-ignite. Particularly when
mixed with remainders of varnish, polyurethane
or other chemical materials and when the sand-
ing debris is hot after long periods of working.
❏ When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
❏ Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
❏ Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from light
alloys can burn or explode.
❏ Always wait until the machine has come to
a complete stop before placing it down.
The tool insert can jam and lead to loss of control
over the power tool.
❏ Never use the machine with a damaged
cable. Do not touch the damaged cable
and pull the mains plug when the cable is
damaged while working. Damaged cables
increase the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with inter-
nal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its
place by an authorised customer service agent. The
replacement plug should have the same fuse rating
as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual cur-
rent of 30 mA or less.
❏ Use only original Würth accessories.
8.12.09