How To Reverse And Install The - LG LTCS20220 Série Manuel D'utilisateur

HOW TO REVERSE AND INSTALL THE REFRIGERATOR DOORS (on some models)
You may find it more convenient to have the doors converted from the left opening type (factory installed) to the right
opening type. Directions refer to the right side as the side on your right as you face the unit.
Door reversal must be done by an authorized installer or service person. If it is not, the doors will not be
covered by the warranty.
REVERSIBLE DOORS MODELS
LTCS20220* LTWS24223*
LTCS24223* LTCS20020*
LTNS20220* LT57BPSX
GT66BP* LTCS20030*
GT58BP* LTCS20040*
Before you begin, either unplug the refrigerator or turn off the power at the circuit breaker or fuse box. Remove
food and any door rack from the refrigerator. Failure to do so could result in death or serious injury.
1. Removing Freezer Door
Gently pry off the top hinge cover with a flat head
screwdriver and remove.
Using 10mm or 3/8 inch socket wrench, remove the
three bolts and lift off the top hinge. Set parts aside
Slightly lift up the refrigerator door and remove it.
Middle Hinge Bracket
Turn the freezer door upside down on a non-scratch
surface. Loosen the screw to remove the Door
Closer/Stop and Hinge Pin Insert.
REFRIGERATOR INSTALLATION
Hex Socket Wrench
ELECTRICAL SHOCK HAZARD
Hinge Pin
CAUTION
TOOLS YOU MIGHT NEED OR USE
m
Phillips Screwdriver No. 2
WARNING
Move the Hinge Pin Insert Bracket to the other side of
the door, keeping the same orientation, and move the
Hinge Pin Insert into the hole on the left side of the
bracket.
Reverse the Door Closer/Stop by flipping it over. Place it
on top of the Hinge Pin Insert Bracket, and tighten bo th
down with the screw.
Pry off the cover on the top left side of the refrigerator to
uncover the screw holes.
Set the freezer door and top hinge parts to the side and
remove the refrigerator door.
8
Flat Head Screwdriver
Hinge Pin Insert
Hinge Pin
Insert Bracket
Cover
(on top of
refrigerator)