LG LTCS20220 Série Manuel D'utilisateur page 11

Door
Closer/
Stop
Reverse the Door Closer/Stop by flipping it over. Place
it on top of the Hinge Pin Insert Bracket, and tighten
both down with the screw. Tighten the Hinge Pin
Bracket to the door.
NOTE:The Door Closer Stop is only presented on some
models.
Hinge
Pin Bracket
Hinge Pin
Insert
With a flat-head screwdriver, carefully pry off and
remove the cover over the screw holes on the left side of
refrigerator housing.
Remove the outer lower Decorative Screw from the
housing at the area between the freezer and refrigerator
doors. (You will need this hole for the Middle Hinge
Bracket.)
REFRIGERATOR INSTALLATION
Flip the Middle Hinge Bracket, (flange will now be on
top) position it on left side of the refrigerator and reattach
with two bolts and a Phillips screwdriver. Place the
refrigerator door down over the pin on the bottom hinge.
Place the washer between the refrigerator door and
Hinge
middle hinge and re-attach Hinge Pin to Hinge Bracket
Pin Bracket
with a ¼" socket wrench.
Hinge Pin
NOTE: Bracke
Insert
in the same orientation with its hexagonal end facing
upward.
Door
Closer/
Stop
Insert the Decorative Screw into the outer hole on the
right side of the housing. Attach cover on the right side.
Cover is force-fitted.
REATTACHING THE DOORS
Place the freezer door down over the Hinge Pin on the
Middle Hinge Pin Bracket.
Place the Upper Hinge Pin on top of the freezer door
and line up the Upper Hinge with holes on top of the
refrigerator. Use the three bolts to replace the Hinge.
10
t has been flipped, but Hinge Pin stays
Flange
Middle Hinge
Bracket
Decorative
Screw