Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISCH
USER MANUAL
Congratulations! You just bought a high quality deep fryer, that will guarantee you a lot of
frying-fun. This deep fryer was built in accordance with the European CE-safety standards.
All persons who have not read these instructions for use are not allowed to use this
deep fat fryer.
NEVER leave the deep fryer unattended in the presence of children. ALWAYS be very careful
when using the deep fryer in the presence of children. NEVER let children or disabled persons
use the deep fryer.
Initial operation: we recommend cleaning the oil reservoir and the basket first. To remove the
oil reservoir, just take off the control box. NEVER clean the basket in the dishwasher. Ensure
that the voltage marked on the rating-plate is the same as your mains voltage. ALWAYS plug
in the deep fryer directly on the mains. Never USE an external timer or a remote control
system. DO NOT place the appliances near or on a source of heat (hot-plate, etc.). Pay
attention that the cord does not touch hot surfaces.
Only use the deep fryer for deep-frying purposes.
IMPORTANT: NEVER switch on the deep fryer if it is not filled with or with enough oil or fat.
All defects caused by neglecting this instruction will NOT be repaired under guarantee. You
will find the instructions for melting solid fat further below this page.
ALWAYS fill the deep fryer with oil or fat between the MIN. and MAX. level, otherwise the
safety thermostat switches off. NEVER leave water in the bowl when filling it with oil or fat. In
this case, first remove the cause, allow cooling off and press the RESET button. The fryer is
now ready for use.
NEVER use the deep fryer with the lid on, nor heat up with the lid on.
Before inserting the plug into the socket, first fold out the basket handle and suspend the
basket on the hook. Now turn the thermostat knob clockwise to the desired temperature. The
heating pilot light goes on. As soon as the selected temperature is reached, the heating pilot
light goes out and the fryer is ready for frying. When the oil temperature drops, the heater and
the pilot light will switch back on and will go out as soon as the selected temperature has been
reached. We recommend to use oil instead of fat. If you prefer to use fat, please follow these
guidelines: First use => melt the fat in a pan and pour it over to the deep fryer bowl. Next use
=> carefully prick little holes in the coagulated fat with a blunt object (i.e. back side of a fork)
up to the heating element. Then turn the thermostat knob a quarter of a turn clockwise
(=minute+hour hand on 08.45 u). As soon as the fat is entirely melted you can turn the
thermostat knob to the desired temperature. Then adjust the thermostat knob on the desired
temperature.
Put the previously dried food in the basket (approximately two third full).
Immerse the basket gently in the oil or frying fat to allow the water contained in the food to
evaporate.
IMPORTANT: To avoid damage to the oil, never add salt or spices during the frying. It's better
not to thaw out frozen small portions, this way the quality will be much better. After frying pull
the basket up and suspend it on the hook. Bring the thermostat button back to the position of
the lowest temperature and disconnect the plug. Allow complete cooling before emptying and
cleaning the deep fryer. Only fold in the basket handle when the oil has completely cooled off.
Put the cord into the cord case. Always remove all redundant icing-up in advance, again to
avoid oil splashes.
Never hang the basket, filled with frozen products above the oil. This causes
dangerous splashes of the oil/frying fat.
Never touch hot surfaces, only use handles and knobs.
Supervise your fryer closely, especially when children are nearby.
Unplug the cord of your fryer when it is not in use and before cleaning.
Allow the oil to cool down before handling the parts or before putting on the dust lid.
Never move the fryer as long as the oil or frying fat is hot.
The electrical safety-switch switches off the heating element as soon as the control
box is removed. Nevertheless unplug the cord before removing the control box.
10
Publicité
Table des Matières
