Pressure Washer Terminology; Assembly - Snap-On 691918 Mode D'emploi

PRESSURE WASHER TERMINOLOGY

Following are common terms associated with the use of Pressure Washers:
PSI: Pounds per square inch – common unit measure used for water pressure, air
pressure, hydraulic pressure and pounds of force.
GPM: Gallons per minute (liters per minute [metric]) – common unit measure used
for flow rate of water.
This Pressure Washer requires some assembly. If you have any problems with the
assembly of your Pressure Washer, please call the Pressure Washer helpline at
1-888-278-8092. If calling for assistance, please have the model, revision, and seri-
al number from the data tag available.
1. Using a box cutter, cut open the Pressure Washer carton on top.
2. Carefully remove all items from the box and inspect for completeness (see
Functional Description).
WAND/ GUN CONNECTION
Insert the wand into the gun fitting out-
let. Ensure that the threads are aligned
properly and that the connection is
secure. Securely tighten the nut by hand.
PRESSURE HOSE / WASHER CONNECTION
1. Remove and discard the protective
plastic plug from the high pressure outlet.
2. Connect the high pressure hose
plastic fitting to the high pressure
outlet at the lower back of the unit.
Ensure that the threads are aligned
properly and that the connection is
secure. Securely tighten the nut by
hand.

ASSEMBLY

PRESSURE HOSE/GUN CONNECTION
Unpack the high pressure hose and con-
nect the metal fitting to the gun inlet.
Ensure that the threads are aligned prop-
erly and that the connection is secure.
Securely tighten the nut. Place the gun
into the gun holder on the side of the
Pressure Washer.
11
GARDEN HOSE / WASHER CONNECTION
DO NOT run the pump without the water supply connect-
ed and turned on. Damage to equipment resulting from failure to follow this
instruction will void warranty.
1. Before connecting the garden hose to
the Pressure Washer, connect the
garden hose to the water source and
run water through the hose to flush
out any debris. Shut off the water at
the source.
2. Attach garden hose to the Pressure
Washer coupling inlet at the lower
front of the unit. Ensure that the threads are aligned properly and that the con-
nection is secure. Securely tighten the nut by hand. Turn on the water source.
For best result, use a short garden hose (30 ft. or less
length), cold water (less than 100 F) and adequate pressure (no less than 50 PSI).
POWER SUPPLY CONNECTION
KEEP all electrical connections dry and off the ground.
NEVER touch the plug with wet hands.
NEVER cut or remove grounding blade (round longer pin) on GFCI
attachment plug.
1. Connect the Pressure Washer GFCI power cord to
a dedicated electrical outlet.
2. Press the RESET button on the GFCI to ensure its
proper operation.
Outlet capacity must be 120V, 60HZ and minimum 15 AMP.
PRESS
RESET
12