Ground-Fault Circuit - Interrupter Protection; Grounding Instructions; Extension Cord Usage; Functional Description - Snap-On 691918 Mode D'emploi

GROUND-FAULT CIRCUIT - INTERRUPTER PROTECTION

This Pressure Washer is provided with a Ground-Fault Circuit-
Interrupter (GFCI) built into the plug of the power supply cord. This
device provides additional protection from the risk of electric
shock. Should replacement of the plug or cord become necessary,
use only identical replacement parts that include GFCI protection.

GROUNDING INSTRUCTIONS

The electrical power source for this product MUST be grounded in order prevent
possible electric shock or even death should the tool malfunction or breakdown.
Grounding provides a path of least resistance for electric current thus reducing the
risk of electrical shock. The power source must also use a minimum 20A service
and not used if other power tools on the same circuit are in use.
This product is equipped with a grounded 3-wire power cord with a 3-prong plug.
If the power cord will not fit into the wall plug, an approved adapter can be used as
long as it is connected to the center screw in the wall plate. Never modify the elec-
trical plug by cutting off the grounding prong so it will fit into unapproved, un-
grounded electrical receptacles.
If you have questions about hooking up this product, contact a certified electrical
contractor to install the proper circuitry acceptable for this and other power tools you use.
Repair or replace any damaged electrical wiring IMMEDIATELY.
GROUNDED RECEPTACLE
POWER CORD
UNGROUNDED AC RECEPTACLE
COVERPLATE
MOUNTING SCREW
GROUNDING ADAPTER
POWER CORD
9

EXTENSION CORD USAGE

Extension cords are not recommended for use with this product. Extension cords, if
used, must be properly grounded with a 3-prong plug on one and a 3-hole receptacle
on the other. DO NOT use grounding adapters with an extension cord. Extension
cords must be UL listed and use a minimum of 12 A.W.G. wiring. Extension cords
should never exceed 25 feet in length. Extension cords, that are too long, cause a volt-
age drop over the extra distance causing the motor to run slower with the possibility of
causing damage to the motor. Using extension cords with smaller than the recom-
mended wire gauge run the risk of getting too hot, melting, and/or causing fires.

FUNCTIONAL DESCRIPTION

PRESSURE WASHER FEATURES:
Gun
1.
2. Adjustable Nozzle
3. Pressure Adjust Collar
4. Wand
5. Trigger
6. Trigger Safety Lock
7. Handle Release Button
8. Gun Holder (Top)
9. Detergent Tank Lid
10. Retractable Handle
11. Pressure Washer
12. GFCI Power Cord (not shown)
13. High Pressure Outlet (not shown)
14. Gun Holder (Bottom)
15. Garden Hose Coupling/Water Inlet
16. On/Off Switch
17. Nozzle Cleaning Needle
18. Pressure Hose
10