Snap-On 691918 Mode D'emploi page 12

TROUBLESHOOTING GUIDE
Problem Probable Cause
1. Clogged Nozzle.
2. Wand is attached
incorrectly.
3. Clogged filter.
4. Kink in the Garden
Hose or Hose is
wrapped on a storage
No water coming out of
wheel.
Wand
5. Gun/Hose Assembly is
defective.
1. Diameter of garden
hose is too small.
2. Water supply is
restricted.
Unit does not reach
3. Not enough inlet water
maximum pressure or
supply.
pressure is irregular
4. Garden Hose length is
too long.
Solution
1. Clean Nozzle (See
instructions).
2. See instructions.
3. Clean filter (see
instructions)
4. Unwrap the Garden
Hose and lay it out flat
to ensure that there
are no kinks in the
Hose.
5. Remove Wand from
the Gun and squeeze
trigger to ensure that
the water is coming
out of the front of the
Gun at a rate equal to
the Garden Hose. Call
Customer Service:
1-888-278-8092.
1. Replace with a 5/8
inch or larger garden
hose.
2. Make sure garden
hose has no kinks,
leaks and blockage.
3. Open water source
fully.
4. Shorten the length of
the Garden Hose. We
recommend a maxi-
mum length of 25 to
50 feet for City water
supply and 30 feet for
Well water supply.
21
TROUBLESHOOTING GUIDE
Problem Probable Cause
5. Water supply is over
I00°F.
6. Water inlet filter is
clogged.
7. Water leaking from
either Hose or Unit.
8. High pressure hose is
blocked or leaks.
Unit does not reach
maximum pressure or
9. Spray wand is on low
pressure is irregular
pressure position.
10.Nozzle worn or not
correct size.
11.Gun or Hose failure.
12.Pump sucking air
from hose connec-
tions.
13.Pump, Unloader or
Valves are clogged or
worn.
1. Spray wand is in high
pressure position.
2. Detergent is too thick.
3. Damaged or clogged
No detergent
detergent suction tube.
4. Nozzle is clogged with
debris.
Solution
5. Provide cooler water
supply.
6. Clean the Screen filter
(see instructions).
7. Stop water from
leaking before using
the unit or Call
Customer Service:
1-888-278-8092.
8. Clear blocks in high
pressure hose or
replace hose.
9. Turn spray wand to
high pressure
position.
10.Replace nozzle.
11.Call Customer
Service:
1-888-278-8092.
12.Make sure connection
fittings are properly
tightened.
13.Call Customer
Service:
1-888-278-8092
1. Turn Pressure Adjust
Collar to low pressure
position.
2. Dilute detergent.
3. Call Customer Service:
1-888-278-8092.
4. Unclog nozzle using
provided cleaning
needle.
22