Snap-On 691918 Mode D'emploi page 11

TROUBLESHOOTING GUIDE
Problem Probable Cause
5. No AC power at the
outlet.
6. Main voltage supply is
too low.
7. Extension cord is too
long or wire size too
small.
8. Defective ON/OFF
Switch.
9. Defective GFCI Plug.
Unit will not start (when
10. Defective Gun.
trigger is depressed)
1. Circuit (outlet) over-
loaded.
AC outlet circuit breaker
2. Extension cord is too
trips
long or wire size too
small.
3. Nozzle partially
blocked causing
excessive pressure.
Solution
5. Main circuit breaker is
tripped or outlet is faulty.
6. Make sure main supply
voltage is adequate
(See specifications).
7. Remove extension cord
or use proper extension
cord (See instructions).
8. Call Customer Service:
1-888-278-8092.
9. Call Customer Service:
1-888-278-8092.
10. Turn off the unit.
Remove the Gun and
Hose assembly from
high pressure outlet in
the back of the unit.
Redirect the outlet to a
safe direction and
switch ON the unit. If
the unit starts and
water comes out of the
front, the Gun may
need to be replaced.
Call Customer Service:
1-888-278-8092.
1. Make sure circuit is
rated at 15 amps or
greater and unit is
plugged into a
dedicated circuit.
2. Use proper extension
cord (see instruc-
tions).
3. Clean Nozzle (see
instructions).
19
TROUBLESHOOTING GUIDE
Problem Probable Cause
1. Extension cord is too
long or wire size too
small.
Motor stops suddenly
2. Thermal safety switch
has tripped due to
overheating and over-
work.
1. Gun/Hose Assembly is
defective.
Unit will not stop when
trigger is released
1. Overheated, over-
loaded or damaged
Unit begins to smoke
motor.
1. Gun Safety Lock in
Trigger will not move
engaged.
1. Loose fitting.
Gun/Hose - Leaking water
1. Pump is sucking air.
Pump is noisy
Solution
1. Remove extension
cord or use proper
extension cord (See
instructions).
2. Make sure main supply
voltage corresponds to
specifications. Allow to
cool and restart unit.
1. Remove Wand from
the Gun and squeeze
trigger to ensure that
the water is coming
out of the front of the
Gun at a rate equal to
the Garden Hose. Call
Customer Service:
1-888-278-8092.
1. Turn off unit and Call
Customer Service:
1-888-278-8092.
1. Release Safety Lock
(See instructions).
1. Tighten fittings. If per-
sists, Gun/Hose will
need to be replaced.
Call Customer Service:
1-888-278-8092.
1. Make sure hoses and
fittings are air tight.
Turn off machine and
purge pump by
squeezing trigger gun
until a steady flow of
water emerges through
the nozzle.
20