Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PROBLEMS
Your iron
produces little
to no steam.
The soleplate
is scratched or
damaged.
The iron steams
once the water
tank has been
filled.
The spray does
not spray water.
Your iron is not
hot enough
If you have any problems or queries please call our Customer Relations
team first for expert help and advice: consult our website for contact details
POSSIBLE CAUSES
The water tank is empty.
The anti-limescale collector
is dirty.
Your iron is clogged up with
limescale.
Your iron has been used for too
long in the dry ironing function.
The chosen temperature is too
low and does not allow the
formation of steam.
You have placed your iron on a
metallic iron rest or ironed over
metal zips or fasteners.
The steam control dial is not
set to
.
The water tank is too full.
The water tank is not full
enough.
Your iron remained unused.
The electronic Auto-stop
system cut the power.
www.t-fal.com
SOLUTIONS
Fill it up.
Clean the anti-limescale collector.
Clean the anti-limescale collector and
steam chamber.
Clean the steam chamber.
See the chapter "Adjusting the
temperature and steam".
Always place your iron on its heel rest
when not in use.
Do not iron over metal zips or fastners.
Ensure that the steam control dial is
set to
.
Do not exceed the max level for filling.
Add water to the water tank.
See the chapter "Auto-Stop Function".
www.t-fal.ca
16
Publicité
Table des Matières
