Safety Instructions - Wamsler M-LINE Mode D'emploi

SAFETY INSTRUCTIONS

1. This equipment has been certified under the requirements of standard
EN 13240 (see the model plate).
2. For setting purposes and connection to the chimney, the fire protection
requirements as prescribed in the given locations, as well as standards
DIN 4705, DIN 18160, DIN 18896, EN 13384, EN 1856-2 and EN 15287
should be complied with. For the problem-free functioning of the equip-
ment, the chimney that the fireplace is to be connected to has to be in
perfect conditions (mainly Germany).
3. Before the first commissioning and connection to the chimney, these user
instructions are to be read thoroughly, and the competent chimney
sweeper has to be informed.
4. It is recommended to use clean cotton gloves for the setting of the equip-
ment in order to avoid the appearance of fingerprints that would be hard
to eliminate later on.
5. In order to keep the air clean and maintain the equipment properly, the
maximum fuel quantities specified in these safety instructions may not be
exceeded, and the doors of the equipment have to be kept closed, other-
wise the equipment may overheat, leading to damage. No guarantee is
provided for such damage.
6. During operations, the doors of the equipment are to be kept always
closed.
7. Permissible fuels:
- natural wood (max. 25 cm in length)
- brown coal briquette (see user instructions)
8. Never use liquid igniters. Use special ignition materials or wood wool for
the kindling of the fire.
9. Never use wastes, fine wooden chips, mulch, coal debris, particle board
wastes, wet wood or wood treated with wood-protective agents, paper or
cardboard or similar materials for burning.
10. Upon the first kindling, smoke and unpleasant smell may be generated.
Always ensure the proper ventilation of the room (by opening windows
and doors), and heat the fireplace at maximum rated heating perform-
ance. If with the first heating the maximum temperature is not reached,
the above-mentioned effects may as well arise later on.
11. The operating elements and adjustment units are to be used as described
in these user instructions. If the equipment is hot, use auxiliaries or pro-
tective gloves for the handling of the equipment.
12. When opening the furnace chamber door, any incorrect handling or insuf-
ficient draught may induce smoke. Always ensure that the furnace cham-
ber door may be opened only slowly, first just to a small extent, and then
fully after a few seconds. In addition, if you intend to put additional fuel in-
24