Samsung WW22K6800A Série Manuel D'utilisation page 51

Problem
Stops.
Fills with the wrong
water temperature.
Load is wet at the
end of a cycle.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and press the Start/Pause button to start the
washer. For your safety, the washer will not tumble or spin
unless the door is closed.
• Before the washer starts to fill, it will make a series of
clicking noises to check the door lock and does a quick drain.
• There may be a pause or soak period in the cycle. Wait briefly
and the washer may start.
• Make sure the mesh filter of the water supply hose at the
faucets is not clogged. Periodically clean the mesh filter.
• If the washer is not supplied with sufficient power, the
washer temporarily will not drain or spin. As soon as the
washer regains sufficient power, it will operate normally.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush
water lines.
• Make sure the water heater is set to supply a minimum 120
°F (49 °C) hot water at the tap. Also, check the water heater
capacity and recovery rate.
• Disconnect the hoses and clean the mesh filter. The mesh
filter may be clogged.
• While the washer fills, the water temperature may change as
the automatic temperature control feature checks incoming
water temperature. This is normal.
• While the washer fills, you may notice just hot and/or just
cold water going through the dispenser when cold or warm
temperatures are selected. This is a normal function of
the automatic temperature control feature as the washer
determines the water temperature.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
Action
English 51