Samsung WW22K6800A Série Manuel D'utilisation page 26

Installation
*
STEP 6 Power on
Plug the power cord into a wall socket featuring an AC 120 V / 60 Hz / 15 AMP approved
electrical outlet protected by a fuse or circuit breaker. Then, press Power to turn on the
washer.
26 English
A
A
CAUTION
• Connect the hose guide (A) within 6 in.
(15 cm)* from the end of the drain hose.
If the drain hose is extended beyond
the end of the hose guide, moulds or
microorganisms could spread inside the
washer.
• The drain hose can be installed up to
96 in. (245 cm) high, but the draining
capability can be reduced at the
maximum height. Remaining water in
the drain system may cause an odour.
• If the drain hose is installed less than
18 in. (46 cm) high, water can be
drained during the process due to a
siphon phenomenon. If this happens, an
information code of '4E' appears on the
display.
Wall standpipe drain system
The drain hose must be placed into a wall
standpipe drain system. To keep the end of
the drain hose bent, use the supplied hose
guide (A). Secure the guide to the wall
using a hook to ensure stable drainage.