BH FITNESS YC1000 Mode D'emploi page 17

10. FITTING THE FOOTRESTS.-
Next, remove the screws (30), the flat
washers (24-25) and the nuts (26) and
position the right footrest (29R) (marked
with the letter "R") on top of the unit's
right foot (19R), Fig.12, (left and right
refers to the user's position doing
exercise).
Refit the screws (26), the washers (24-
25) and the screws (30) removed
previously and tighten securely.
Next, position the left footrest (29L)
(marked with the letter "L") on top of the
left foot (19L), refit the nuts (26), the
washers (24-25) and the screws (30)
removed previously and tighten securely.
11. FITTING THE HANDLEBAR.-
Take the handlebar (4), remove screws
(11), position the ends of the handlebar
on the plate at the top of the main post
(78), Fig.13. Refit the screws (11)
removed previously.
12. FITTING MONITOR.-
ATTACHING THE FEEDBACK CABLE.
Take hold of the cable (86), which is
sticking up out of the main post (78),
Fig.14, and plug it into the connector of
the electronic unit (1), as shown in
Fig.14
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(2), sticking out of the main post (78),
and plug them into the connectors
located at the back of the monitor (1), as
shown in Fig.14.
ATTACHING THE MONITOR.-
Release screws (84), Fig.14, at the back
of the monitor.
Next, slide the front of the monitor onto
the plate on top of the main post (78) in
the direction of the arrow, Fig.14, push
the cables down into the main post
making sure not the pinch any of the
cables. Replace
removed previously.
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
EXERTION SETTINGS.-
To provide an even level of exertion
during exercise,
equipped with a tensioning control (79),
located on the main post (78), offering
various exertion settings, Fig.14.
To increase pedal resistance turn the
tensioning control (79) clockwise (+)
until the exertion level best suits your
exercise requirements.
To reduce pedal resistance turn the
tensioning control (79) anticlockwise (-).
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This can
be achieved by screwing the adjustable
feet (46) up or down, as shown in
Fig.15.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (72) to
make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen position,
by lifting the rear of the unit up slightly
and pushing it, as shown in Fig.16.
Store your unit in a dry place, preferably
not subject to changes in temperature.
17
the screws (84)
this appliance is