Final Installation; Water Filter Installation; Preparation For Use - Dacor DTF364SIWS Manuel D'utilisation

Final Installation

1. Push the refrigerator
into its final position.
Be careful not to
trap the power cord
or water supply line
behind the unit.
WARNING
While adjusting the feet, disconnect the
power plug to avoid the risk of electric
shock.
2. If the refrigerator is not level or balanced
after installation, adjust the feet. Having
someone to push on the refrigerator will
facilitate this process. Turn the front feet
to level the unit.
3. Connect the power plug to the electrical
outlet.
4. Turn on the water supply. Check for
leaks.

Preparation for Use

• Clean the inside of your refrigerator
thoroughly before using it for the first
time. See the Care and Cleaning
section.
• Run the refrigerator without putting any
food inside for six hours. Do not open
the doors unless absolutely necessary.
It is normal to hear noise when the
compressor starts up. The liquids and
gases sealed within the refrigeration
system may also make noise, even if
the compressor is not running the whole
time.
Installation
• It is normal for the front edges of the
refrigerator may feel warm. These areas
are heated to reduce condensation.

Water Filter Installation

• Turn off the ice maker and disconnect
the power plug before removing the
filter bypass.
• The water filter cleans some foreign
particles in the water. It does not purify
water from microorganisms.
The refrigerator is equipped with an internal
water filter. To install the water filter:
1. Touch the Ice key on the control panel to
turn off the automatic ice maker.
2. Disconnect the power plug from the
electrical outlet.
3. Remove the crisper drawers to access
the filter connector in the back of the
refrigerator compartment.
8
WARNING