AIRHEAD 9095293 Manuel Du Propriétaire page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Your AIRHEAD inflatable is equipped with one or more of the following valve types:
Speed Safety Valve: Pulls out for fast inflation/deflation, then can be pushed in flush with the tube.
Secure the valve by firmly fastening the bottom portion of the valve into the base. To inflate, open cap
or top portion of the valve. Using the hose from your inflator, inflate through the top opening of the
valve.
Boston Valve: Inflating: Be sure that the Boston Valve is tightly installed by turning the square base
clock-wise. Unscrew the top cap counter-clockwise. Inflate using an AIRHEAD air pump. Deflating:
Remove the entire valve by turning the square base counter-clockwise.
Stem Valve: Affix the end of your inflator hose into the opening in valve. Make sure you open the flap
inside the opening and inflate until firm. Deflate using your AIRHEAD pump, or insert a blunt object to
open the flap.
MONITORING & MAINTAINING PROPER INFLATION
To prevent serious damage to seams and I-beams, remove some air or move to a shaded area
when exposure to direct sunlight heats up the tube and causes the air inside to expand. Add
some air if exposure to cool air or water lowers the air pressure inside.
TROUBLESHOOTING GUIDE
Product won't hold air: Make sure that the valve is installed properly by removing and re-installing. If you
suspect that the product was not inflated fully, add some air.
Valve is leaking: Make sure that the valve was screwed into the threads correctly. Valve and cap must be screwed
down tightly.
Bladder does not get firm and/or Nylon Cover is loose: Your air pump probably doesn't produce enough pressure
to completely fill the bladder. Top off your inflatable with an AIRHEAD Double Action Hand Pump or Foot Pump.
KWIK CONNECT TOW SYSTEM
Follow the instructions below to properly attach a tow rope when using this system.
TOW CONNECTION SET-UP:
If your product has this type of system please refer to the diagram below. Loop the top nylon strap through the bottom
loop and pull up tautly on the nylon strap. Affix your rope to the nylon strap and you will be ready to go.
1
Special Note: The tow system should only be used as shown in this diagram. Towing from the top or bottom strap
alone will cause the tube to function incorrectly and may risk damage to the cover or tube. Damaged caused by
improper use will void your warranty.
1
2
3
2

Publicité

Table des Matières
loading

Table des Matières