Section 7. Install Settings; Freeze Protect; Important - Zodiac AquaLink Z4 Manuel D'installation

Section 7. Install Settings

Install Settings is a hidden menu, mostly used for setup
and reference purposes.
Settings available through this menu:
•

Freeze Protect

Automatically turn specific equipment on to protect
against freezing temperatures.
• Units
Change units of measurement displayed on the User
Interface (temperature and time format).
• Language
Change language displayed on the User Interface.
• Clear Memory
Clear all programmed data in the controller for all
equipment.
• Pump
Assign a one-speed, two-speed pump or variable-speed
pump to the controller.
• Color Lights
Only available if specific lights are installed in your
configuration.
• Label Aux
Assign custom labels to auxiliary equipment, such as an
air blower, cleaner, solar pump, etc.
• Temp Calibrate
Adjust temperature displayed on the User Interface up or
down by four (4) degrees.
• Solar Priority
Only available if solar heating is installed in your system.
• Assign JVA
Assign Jandy Valve Actuators (JVAs) to specific AUX
®
relays, as intake or return in Pool Only mode.
• Ext. SWC Power
Only available if a salt water chlorinator (SWC) is
installed in your configurations.
• Assign Hotkeys
Only available if AquaPalm
configuration.
• Diagnostics
Display software revision information and alerts for
troubleshooting purposes.
AquaLink Z4 Controller
®
is installed with your
™
|
Installation Manual
To access the Install Settings Menu:
• Press and hold Up/Down arrow keys at the same
time for about 5 seconds.
Zodiac
12:40PM
Zodiac
Pool Mode On
12:40PM
Pool Heater 80°F
Aux1 O
Pool Mode On
Aux2 O
Pool Heater 80°F
Settings >
Aux1 O
Devices >
Aux2 O
Settings >
Devices >
INSTALL SETTINGS
Color Light INSTALL SETTINGS >
Label Aux >
Temp Calibrate >
Color Light >
Solar Priority >
Label Aux >
Assign JVA >
Temp Calibrate >
Assign Hotkeys >
Solar Priority >
Assign JVA >
Assign Hotkeys >
7.1 Freeze Protect
NOTE By factory default the filter pump circuit is freeze
protected. During freeze protection, the filter
pump cannot be turned off.

IMPORTANT

Freeze protection is intended to protect equipment
and plumbing for short periods of freezing only.
It does this by activating the filtration pump and
circulating the water to prevent freeze inside
equipment or plumbing. Freeze protection does
not guarantee that equipment will not be damaged
by extended periods of freezing temperatures or
power outages. In these conditions, the pool and
spa should be shut down completely (e.g. drained of
water and closed for the winter) until warmer weather
exists.
Activating the spa during freezing conditions will
override freeze protection. This means that if you are
using your spa when freezing conditions exist, freeze
protection will not circulate water to non-spa related
equipment that you may have freeze protected
(e.g. pool cleaner, booster pump.) Under these
circumstances, the potential for equipment damage
may exist.
ENGLISH
Page 15
INSTALL SETTINGS
Freeze Protect >
INSTALL SETTINGS
Units >
Language >
Freeze Protect
Clear Memory >
Units
Pump >
Language
Clear Memory
Pump
More
More
INSTALL SETTINGS
Diagnostics INSTALL SETTINGS
Diagnostics
CAUTION
>
>
>
>
>
>
>