General Points; Unpacking The Harmonys; Cleaning; Pré-Requisit - Bodet HARMONYS Notice D'installation Et D'utilisation

1. GENERAL POINTS

Thank you for choosing the Bodet HARMONYS LED Flash. This product has been carefully designed to meet your
needs in accordance with ISO9001 quality standards.
We recommend that you read this manual carefully before using the product for the first time.
Retain this manual throughout the lifespan of your product so that you can refer to it when necessary.
Failure to follow these instructions may cause irreversible damage and invalidate the warranty.
Non-contractual data. BODET reserves the right to make certain changes to its devices, regarding functional,
technical, aesthetic or colour characteristics, without prior notice.
This manual is subject to change without notice. To obtain the most recent version of this document, please refer to
our website: www.bodet-time.com.
1.1 Unpacking the Harmonys LED Flash for outdoor environment
For 907794, it must contain :
• Harmonys LED Flash control box,
• LED beacon strobe light,
• Information plate,
• This document.

1.2 Cleaning

Use an antistatic product.
Never use alcohol, acetone or other solvents which may damage product casing.
1.3 Pré-requisit
For the commissioning of the Harmonys LED Flash, you must install the SIGMA software (supplied on CD with your
master clock) on your PC. To download the latest version of the software, contact our export department who will
send you the download links by email: export@bodet-timesport.com.
To check compatibility of your equipment and the software version, please have the version of your
master clock.

1.4 Safety instructions - Precautions for use

This equipment must be fitted and maintained by a qualified person.
The Outdoors Harmonys LED Flash connects to the mains power supply. The installation must comply with stan-
dard IEC 364 (NFC 15-100 in France).
The product must be powered by the building's electrical system. It is designed for category II overvoltages. Clipping
max: 2500 V (provide protection on the power supply if necessary).
Cables must be tightened at the glands to ensure that no stress is placed on the connection terminals. Furthermore,
conductors on the same circuit must be attached to each other close to the terminal block to avoid reduced isolation
should one of the terminals become loose.
Provide a Phase-neutral circuit breaker of 16 A maximum, rapidly accessible upstream from the power-supply line.
This circuit breaker provides power supply protection and disconnecting, and must be cut off in the event of main-
tenance.
The equipment must only be powered up after it has been attached.
4
EN EN