Digitus DS-55306 Mode D'emploi page 8

FAQ
Q: Transmitter and receiver can't be connected with each other?
A:
1) Please check if the wireless connection light on product blinks
properly.
2) Restart the transmitter or receiver.
3) Reconnect the HDMI cable or use another HDMI cable and try again.
4) Please change the location of sender (TX) and receiver (RX) and make
sure devices is within the signal coverage.
Q: The Wifi LED indicator of the transmitter keeps on, but no signal
output on display/monitor?
A:
1) Please check if there is an HDMI signal input of sender TX
2) Try to connect the signal source directly to display device to see if
there is signal output from source device or change the signal source,
the resolution of input signal, HDMI cables and try again.
Q: Display not fluent and stable
A:
1) Please change the location of sender (TX) and receiver (RX) and make
sure devices is within the signal coverage.
2) Restart the transmitter or receiver.
3) Reconnect the HDMI cable.
4) Remove other wireless signal disturbance and reduce the obstacle on
the way.