Revell Control NANO POCKET Mode D'emploi page 12

3 INSERTING BATTERIES (REMOTE CONTROL)
3A In order to insert the batteries, open the remote control and
remove the battery holder (2I) and battery cover (2J) by unscrewing
the two screws.
3B Insert 4 x 1.5 V AA batteries and pay attention to the polarity
specifications, as indicated in the battery compartment.
3C Replace the battery cover (2J) and carefully screw in both screws.
The battery holder (2I) has a long tab and a short tab. The short
tab should be inserted at the top and the long tab pressed down at
the bottom.
4 CHARGING THE MODEL
Attention: The battery and motor must cool down for 15 to 30
minutes before charging and after every flight. Otherwise they can be
damaged. The charging process must be constantly monitored. Always
ensure that the charging process takes place on a fireproof surface in a
fire-resistant environment.
4A Switch off the ON/OFF switch of the model (1C), then switch off
the remote control by pressing and holding the ON/OFF button (2L)
(only if the remote control is still switched on).
4B Insert the charger plug (2F) in the charging socket (1B) of the
model. The charger plug must be gently inserted into the charg-
ing socket – DO NOT USE FORCE. If the charger plug is not correctly
inserted into the charging socket, the battery may become damaged
and, under certain circumstances, cause injury.
4C The charge indicator (2G) will light up red when charging begins.
The charging process lasts approx. 40 minutes and must be con-
tinuously monitored. As soon as the charging process is complete,
the charge indicator goes out. Disconnect the model from the
charger plug when the charging is complete.
The model can fly for approx. 4-6 minutes after a charge time of
approx. 40 minutes.
Warning notice: The battery does not normally heat up while
charging. If it should become warm or even hot and/or changes to the
surface begin to appear, immediately discontinue the charging process!
22 22 22
5 START PREPARATION
The model must be switched on first in order to connect it to the
remote control. For this purpose, set the ON/OFF switch on the model
(1C) to the ON position (5A).
The control for thrust and rotation (2A) must point down before the
remote control is switched on. To switch on the remote control, briefly
press the ON/OFF button (2L). The remote control issues a short beep
as confirmation (5B). Then briefly move the control for thrust and
rotation (2A) all the way forward and back again (5C). After approx. 3
seconds, the model activates and is ready for use.
After flying, switch off the model first, then the remote control by
pressing and holding the ON/OFF button (2L) for about three seconds.
6 TRIM ADJUSTMENT OF THE CONTROL
The correct trim is a basic requirement for fault-free flying behavior of
the model. Its adjustment is simple, but it requires some patience and
a feel for it. Please observe the following instructions precisely:
Carefully move the thrust control up and raise the copter approximately
0.5 to 1 metre in altitude.
6A If the model automatically moves slowly or quickly to the
left or right ...
gradually press the trim for sideways flight (2D) in the opposite
direction.
6B If the model automatically moves slowly or quickly forwards
or backwards ...
gradually press the forwards/backwards trim (2C) in the opposite
direction.
23 23 23